Before deciding on what device to buy, I was having the hardest time getting down my measurements. In a flash of inspiration, I remembered, that among my other bondage toys, I had a 2 inch diameter ring. I was / am able to wear the ring comfortably. ... Perhaps too comfortably. One morning after wearing it to sleep, I found that it worked itself off. If I were to wear a similar (I'm guessing 50 mm) sized holy trainer, is it safe to assume it too would slide off?
Not nececelary, remember that your junk is mostly totally soft and floppy, so leaves plenty of room for the plums to squeeze through. Not so with the fairly rigid tube of the HT in the way. In fact I'd say there is no way it's going to pull through completely, as the gap there is really pretty small.
Hi mendle. I have a HT2 and I have slipped out once over night. Unfortunately sizing is not an exact science as the ball trap devices it's not just the ring size that counts but the gap between the ring and the cage as well. Although I do think th HT2 is a good device it is probably better to buy a cheap copy of a CB6000 with a lot of rings whilst the device is rubbish ( I mean the copies the original seems fine) they are very low cost and will allow you to accurately size your self. For me the ring has to be both very close to the tube and quite tight for any device to work. Once you are comfortable with the size then but the correct size HT2. It's worth noting that most people need a smaller ring size on the HT than on the CB range as the ring is better anatomically designed. Wishing you the best of luck. By the way the cheap devices can and do fall apart often so I would only use it as a sizing tool.
I been wearing HTv2 for last 18 days - I guessing your ring is too big- I loaded trucks in hot weather, slept, worked I wearing 45mm ring
I do have acouple of questions. I'm not too clear on the Holy Trainers 1 or 2. Is it possible to utilise a pa to boost security with these devices? Are the Holy Trainers not as rigid as the cbX range?
PA: No personal experience there I'm afraid.... CB range: I've never touched one so cant say for sure, but the HT material is not rigid plastic, it has some give to it. Not a lot granted, but some. I think that's partly what makes it such a comfortable cage to wear - though I could be wrong.
Placing the HT cage and base ring in warm water will allow the cage to flex. You can mold it to your needs. Jay.
I'd noticed that in warm water the material became softer, but never clocked wether it could be moulded while soft. If so then a very nice feature.
I wear a HTv2 now for 60 days now in a row and can't complain. My ring is a 45 mm ring and I tried a 50 mm ring, but for me that was not good so I stick now with the 45mm ring and the standard length tube. I have worn the Original CB2000 and CB3000 and compared to these two the HTv2 is much more comfortable. It still wakes me up, but not because of the pain, just because my friend down there becomes really ambitious during night. Short wake up, apply some lubricant between the ring and the scrotum and good to go to rest again. Sometimes I only pull slightly the under side of my scrotum skin from under the ring and that works also. But when you have no experience with the ring size, the advice to try with a cheap device is best to follow. Good luck, Felix