#3 ring

Discussion in 'CB Range' started by juniorbottom, May 19, 2014.

  1. juniorbottom
    Offline

    juniorbottom Member

    Joined:
    Oct 19, 2009
    Messages:
    134
    Likes Received:
    105
    Trophy Points:
    28
    Gender:
    Male
    Local Time:
    2:09 AM
    Is anyone currently using the #3 ring on the cb-6000s? Or has anyone ever used it? It seems pretty small. I have tried it before but i have had some pain and had to switch it with the #2 ring. Maybe I didnt give it enough time to get used to.
     
    D6000 likes this.
  2. lockit
    Offline

    lockit Advanced Member

    Joined:
    Mar 4, 2010
    Messages:
    1,968
    Likes Received:
    1,047
    Trophy Points:
    153
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    London
    Local Time:
    8:09 AM
    I have had to go down to the third ring. I went down to the second after my first 9 months or so in chastity.
    I had a little bit of discomfort while adjusting to it.
    However after a few weeks I was back to normal.
    The move to the third ring has been a nightmare. Over three month and I still have problems.
    It has been getting better however a very slow proccess.
     
  3. juniorbottom
    Offline

    juniorbottom Member

    Joined:
    Oct 19, 2009
    Messages:
    134
    Likes Received:
    105
    Trophy Points:
    28
    Gender:
    Male
    Local Time:
    2:09 AM
    I feel like i have room to get the #3 on but after a couple of days it starts becoming a bit discomforting. I have been locked for 1 month already and im starting to feel some looseness around the #2 ring. Maybe I will give it a bit longer before going down again.
     
    lockit likes this.
  4. lockit
    Offline

    lockit Advanced Member

    Joined:
    Mar 4, 2010
    Messages:
    1,968
    Likes Received:
    1,047
    Trophy Points:
    153
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    London
    Local Time:
    8:09 AM
    It felt like I was going down two sizes
     
  5. N23orMore
    Offline

    N23orMore Long term member

    Joined:
    Feb 22, 2014
    Messages:
    173
    Likes Received:
    128
    Trophy Points:
    53
    Local Time:
    3:09 AM
    Eventually you will get to the smallest ring you can get in to but if you find yourself getting hard at night due to having to pee or otherwise and your erection will not go back down, you might want to go back up to the next larger size. You need enough space during the night for the fluids to subside and your hardon to go back down, otherwise you will be in quite a bit of pain. Just because you do not have problems with the ring size during the day does not necessarily mean it will work for you at night. Once you get the right ring size if you are having problems with pinching you might want to increase the gap to the next larger size.
     
    lockit likes this.
  6. lockit
    Offline

    lockit Advanced Member

    Joined:
    Mar 4, 2010
    Messages:
    1,968
    Likes Received:
    1,047
    Trophy Points:
    153
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    London
    Local Time:
    8:09 AM
    Going back up is not an option for me. With the second ring my testicals slip out.
    That can be rather painful when trapped half in and half out.
     
  7. chastesoon
    Offline

    chastesoon Senior Member

    Joined:
    May 14, 2008
    Messages:
    584
    Likes Received:
    484
    Trophy Points:
    73
    Gender:
    Male
    Occupation:
    Retired
    Local Time:
    2:09 AM
    I had the same problem with my testicles slipping out. I went to the # 3 ring as you said, ( middle ring ) . I also use the shortest pin and spacer.
    Everybody now stays in place, and I am happily secured. I read somewhere tighter is better. It just takes awhile to get used to it.
     
  8. Tusk11
    Offline

    Tusk11 Active member

    Joined:
    Jun 4, 2014
    Messages:
    57
    Likes Received:
    17
    Trophy Points:
    8
    Gender:
    Male
    Local Time:
    1:09 AM
    I'm having trouble figuring out the adjustment to cb6000 so maybe someone can give advice. Here's my history thus far on using this thing.

    I was in the middle ring/shortest spacer. This seemed uncomfortable as my sac felt inflamed with a lot of pain (especially in the morning). I put a lot of lotion on my sac before bed.

    I went up to the second largest ring/next size up spacer. In the morning I woke up with a raging erection and unbearable pain in the head of my penis. It was trying to get out and I couldn't get myself to deflate. Took off for a couple days. My penis ached every once in awhile so I figured I'd give it a rest.
    I noticed that I had a ridge on the underside of my sac and figured that is what was causing the inflamed pain so I bought some electrical tape and wrapped the next largest ring with it.

    I went to this wrapped second largest ring/shortest spacer. Woke up this morning with huge erection again, not much pain just a lot of discomfort. The ring had pushed my balls way up my shaft. I have a nice hanging sac so it had my balls tout to the skin so I basically had almost a full erection.

    This morning I went back to the middle ring (wrapped)/smallest spacer. I am experiencing a lot of pinching in my sac which really sucks and is not comfortable. I'm also noticing nut pain, or throbbing. Not sure I'm really liking this set up.

    The most comfortable fit I've had was with second largest ring/smallest spacer, but I was able to reach almost a full erection with it on (morning wood). With this on I'm not supposed to reach such an erection am I? I would really like to figure out a way to keep the ring close to my body without pushing my balls so far up my shaft. Any suggestions would be great.

    Thanks, Scott
    Oh and the lest amount of pain, I can't stand pain in this area of my body :)
     
  9. Mistress B
    Offline

    Mistress B Mistress B

    Joined:
    Feb 29, 2012
    Messages:
    2,451
    Likes Received:
    3,511
    Trophy Points:
    153
    Gender:
    Female
    Occupation:
    Business Owner
    Location: (Country, Region - and perhaps even City?):
    United Kingdom
    Local Time:
    8:09 AM
    The larger rings will obviously feel more comfortable on you @Tusk11 but because they are loose and not a snug fit, you will find that you will be more able to achieve an erection. This will cause more pain as the testicles will be stretched. Once the penis is able to harden it will cause you pain. If you can wear a smaller, tighter ring, the penis will find it less able to harden and your testicles will not be stretched. It may take you a little time to get used to a smaller ring but in the end you will find it much more controlling.
     
    Tusk11 likes this.
  10. N23orMore
    Offline

    N23orMore Long term member

    Joined:
    Feb 22, 2014
    Messages:
    173
    Likes Received:
    128
    Trophy Points:
    53
    Local Time:
    3:09 AM
    Also not knowing how much you fill the 6000 cage, it might be too large for you and you might need the smaller 6000s cage which you can buy separately. Like Offline said you might be better with the smaller ring but if so, try and use the larger gap spacers. And be ready to take it off if you are in pain like you talked about. One question, do you have problems during the day like you do at night? When I was having that situation, I found I HAD to go to the larger ring but played with the gap spacers to find the right one. Also, how much are you filling the 6000 cage. just measure from the end of the cage to your penis inside when it is soft and subtract it from the full 6000 cage length. You might need the 6000s cage instead. The 6000 cage is supposed to be 3 1/4" in length compared to the 6000s which is 2 1/2" in length.
     
    Tusk11 likes this.
  11. Tusk11
    Offline

    Tusk11 Active member

    Joined:
    Jun 4, 2014
    Messages:
    57
    Likes Received:
    17
    Trophy Points:
    8
    Gender:
    Male
    Local Time:
    1:09 AM
    So I'm probably going to have to go to a smaller ring, larger spacer. My penis is about an 8th of an inch from the end when completely flaccid. My head is completely in the area shaped for it. I have no problem during the day. I did skip two days this week (wed and thur) but Sunday, Monday, Tuesday and Friday and today been fine. A little discomfort today with pinching of the sac in the ring that's another reason why I was curious about the ring. I'm worried that it will pinch even more. But I'm going to try it because the discomfort of the erection sucks. Really the only problem I have is in the morning when erections are most intense and it's a miserable bitch. If I did have a girlfriend or wife with me in the mornings and she was sadistic I assure you she'd get a kick out of it.

    Thank you both for input and suggestions. This information is definitely appreciated.

    Thanks, Scott

    going to make adjustments now to see how it feels.
     
  12. Tusk11
    Offline

    Tusk11 Active member

    Joined:
    Jun 4, 2014
    Messages:
    57
    Likes Received:
    17
    Trophy Points:
    8
    Gender:
    Male
    Local Time:
    1:09 AM
    Changed to smaller ring, as I'm typing this I am literally squirming. I also used the larger spacer. It really was a chore getting that ring on with the top part in place. I'm sure this is probably just something I need to get used to because I know my penis is no where near as thick as a lot of guys, I've watched enough porn to know that. I am also certain that with this set up there is no way I can get an erection I don't think that the blood flow can get in. But if it does not sure if it can get out. This is a little frightening. I'm going to stimulate myself to see what I can do with it. I don't want to fall asleep and wake up with a case of black cock and balls UGH!!! So I'm a bit afraid of this setup as it is. Still appreciate the help and hoping this is the set up I need and just need to get used to it.

    Scott
     
  13. N23orMore
    Offline

    N23orMore Long term member

    Joined:
    Feb 22, 2014
    Messages:
    173
    Likes Received:
    128
    Trophy Points:
    53
    Local Time:
    3:09 AM
    If you are an 1/8" from the end then you are a pretty good fit for that length cage. If you decide to order a steel one you might be able to take a 1/4" off of the size cage you have now without problems. Using the larger spacer should help with the pinching but the design of the base ring for the cb6000 series cage does cause more possibility for pinching than the round steel of the Jailbird and such. And some lube under the bottom side of your base ring will also help with pinching. Just don't lube the whole thing or you might find it rotating on you during the night. As far as getting out at night be sure you have a key handy till you get the fitting correct. You should not be hurting or cutting off circulation totally with night erections.
     
  14. Tusk11
    Offline

    Tusk11 Active member

    Joined:
    Jun 4, 2014
    Messages:
    57
    Likes Received:
    17
    Trophy Points:
    8
    Gender:
    Male
    Local Time:
    1:09 AM
    Back to the drawing board. :mad: Tried to sleep last night and couldn't. Tried twice (got out of bed to relax after first try). The only reason I gave it a second try was I wasn't sure if maybe I just wasn't used to it. I had read somewhere that once you're used to the cage you won't feel the pulling so much. But the pain both times was incredible. My balls felt like they were in a vice. I just don't know if this is for me. I think I'll give it another go but that smaller ring is retired for good.

    One positive was when I took thing off I was so hard and couldn't sleep without relief. I had the most amazing orgasm. It was first time I felt that fulfilled and completely exhausted after in probably years. Not feeling guilty or like I shouldn't have done it. I've cut myself down to only twice in a week and that's an accomplishment. Who knew that denial mixed with excruciating pain would be so fulfilling.

    Scott
     
  15. N23orMore
    Offline

    N23orMore Long term member

    Joined:
    Feb 22, 2014
    Messages:
    173
    Likes Received:
    128
    Trophy Points:
    53
    Local Time:
    3:09 AM
    Ok Now try the larger ring and a middle to larger gap spacer. Which base ring are you going to be using now?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice