How do you remove your base oval ring on MM devices?

Hi, the only way I know of is to take it off early. I have a double ring so it is twice as hard to get off.

 

Just turn the ring around so she doesn't get poked by the bit that sticks out.

 

Yes the only way is to either take it off before 'play' .. otherwise you'll have problems with the pin and, if you're like me, get hard pretty quickly so it could be some time before you're able to get the ring off

 

She always teases me when I have difficulty getting it off, which of coure makes me harder and it's even tougher to get it off then. A touch of lube helps a lot, and then slowly working some skin through at the top, and pushing a little of my erection through, then a little more skin, etc. It's not a quick process but it doesn't take long enough to kill the mood entirely.

 

That's exactly right. There's no need to remove it. You can simply rotate the ring so that the sticky out bits are behind your testicles.

 

I'm expecting the same problem. I have been wearing a 42mm ring in prep for my new looker. If I get just a little hard it's not comming off. Do as stated above. I will be turning around and take what ever is poking me in the sac.

 

We had the same problem , and MM made a custom "A-Ring" for us with a removable pin. This worked out great for us, but some people do not like wearing the remaining "Cock Ring" part during sex. My KH / Wife enjoys me wearing the double ring. Without the pin it is alot more comfortable for both of us.

 

I will definitely be trying a simple twist of the ring. I'm thinking my ring might be pretty tight when I'm at full attention but I'll give it a try and report back. Whenever she next lets me out of course! Thanks for the suggestion.

Side note: love the avatar pic, 1mlockedup!

 

Revolving the base ring is definitely the way forward. In any position where you service your Lady from on top, the projecting pin or 'sticky out bit' as Ms Snake calls it, is simply no problem at all.

Of course, where Madam assumes the 'on top' position during lovemaking the pin can be really very uncomfortable as it digs into the presumably swollen ball sac, especially when the Lady sits back firmly and repeatedly on the bloated shaft. But then such discomfort only serves to remind one of one's place; the pain should be accepted as an unimportant by-product of Madam's pleasure.

And orgasming through tightly ringed testicles after long-term denial really is a sensation all of its own... I'd recommend it.

 

yep have my device now and the only way that ring is coming off is if i'm soft. so I must turn and if she is on top or not it can hurt but I can take it and if it hurts enough you most likely will not be thinking about cumming.

 

But then some of us find suffering for our Mistress is a pleasure and exciting in its own right... Almost one's duty.

Especially when that suffering is increasing Madam's own pleasure during lovemaking.

She deserves nothing but the ultimate in satisfaction, naturally.

 

That's exactly right.
It also makes it less fiddly to reassemble after I find.

 

Oh the pain ,squeezing my balls out of the ring .after i get the left one out the right is not as bad. Same prob frustrating to remove device while cock is trying to get hard.iv found to just deal w it

 

There's no need to remove the ring.

 

I agree with Miss Snake. Leave it on.

To put on my ring. I pull some skin from my sack thru the ring then pop one and two. I have to find them as they know what is going on and run indoors to hide.. Then I push my unit inside of me. Make it inside out. push just a little bit of skin under the ring then start pulling the skin under the ring until you have enough that you can pull the whole unit out. Remove in reverse order.
On: 1. Sack 2. Testies. 3. Unit
Off: 3. Unit......
You get the point. Maybe we should just leave them on...

Gabby

 

Personally I've found that in all things to do with caging and locking male genitals it's simply best to do as Ms Snake says.

Her advice is always correct and She clearly knows what's best in these matters, as well in most others...

 

Indeed, in the event that she would like to use it then rings should be left on.
The only good reason for taking a ring off would be for the purposes of shaving if you're that way inclined.

 

Up to each Mistress of course, but I think pubic hair is for men with cocks. A slave's baby penis should look the part.

 

Closely trimmed pubes and immaculately shaved testicles is my current preferred regimen... Freshly shaved balls have a vulnerable and clean appeal, which my Mistress greatly prefers.

 

For those that leave their base rings on: how tight/painful does it get when you're fully aroused?

I'm considering getting a locking cock ring front for those times I'll have my cage off (even though the only use I'll be making of it will be via self-stimulation); is this likely to work or be more of a problem? I note that Thumper says that he's glad he didn't specify a smaller gap (like what he has with his cage), so would I likely have problems if I try and use the same Mature Metal base ring for my cage with a cock ring?

I've tried to test this using the plastic sizing rings, but I can't get the one I place on my shaft to stay in position relative to the base ring (as it keeps bending away from the bottom of the base ring as my scrotum contracts) :s

 

I think it better if you just come to terms with the pain

 

If I may ask, why?

1. I'm self-locking, so I won't be impressing/amusing anyone with my coping with the pain;
2. I'm not into CBT, so I won't be enjoying the pain.

 

Ah well if you're self locking then that's a different matter.
Personally I would prefer to leave a base ring in place when having actual intercourse, purely because it's impossible to remove once he's fully erect and secondly his pain or discomfort serves to distract him from the pleasurable sensations and prevent him from climaxing.

 

We can make the cock ring with a different gap than the gap is for the cage. We suggest that you may want to go with one size larger cock ring than the size of your cage. Remember that we will need your base ring sent to us so we can fit it properly.