I have a problem with the penis tube on my dd machinery belt. This belt has a flexible tube at the end of the rigid tube to allow toileting, this tube has split. I have tried replacing it with an inner tube from a bicycle but this removed the skin from my testicles, dose anybody have any ideas.
This is not much help but i had the same issue, the hard ring on the top was damaging my skin still have the scars unfortunate also look out. you have to be very careful to keep the belt dry material doesn't rust, but the welding joints dose
Thanks chastiff for the information. I have been thinking of getting a full belt from DD Machinery for a while.
@chastiff - do you still have the belt, I am not convinced that where the chains are sitting on the belt are correct? @dsinbraces - Hello dickie/Repsctful hello Mistress Suzan - are you still using the belt and is it possible for you to post a picture of the back to show the chains as I don't think mine are sitting in the correct place. Thanks Lucy x
@philfred The chains on dickie's belt are attached at the bgottom of the shield and and come up thewbutt cheeks and are attached to the waist of the belt on either side , about 3 inches from center on either side. The chains cause some discomfort when seated for a long time, or on a hard surface, so I had plastic tubing placed over the chains and then re-attached to the belt. Belt is on loan to a member of our fetish group at this time, as she is considering a purchase of same style. I reccommend the style with the pvc coated wire that runs up between the buttcheeks. Very secure, and sissy can move enough to side when doing number 2. Easy clean up with pvc coating for extended wear. We also had slight problem with silicone padding coming lose after many uses. Handy neighbor friend re-glued with automotive quality adhesive, and that solved problem. As dickie lost weight, we needed to tighten belt as well. Hope that helps Mistress Suzan
The chains on the waist band on mine were at the side so every time i sat down the chains came loose allowing access. I have moved them back about one inch on each side and that seems to have cured the problem. I have tried to replace the tube with heat shrink cable sleeving so far this is ok i will report back.