Tutorial: DIY cable wire support belt.

Here is a tutorial on how I made a chastity support belt to virtually eliminate my turtling issue due to lots of foreskin and a larger than normal fupa. The materials you are going to need are 10ft of 3/32 coated cable. $4 @Lowes. Two 5/16 or 3/8 split washers and two zip ties and a 2" or 50mm solid ring. Tools required: two pairs of pliers and some wire cutters.

1) start with half of your cable and your metal ring. Feed the cable through the ring and back on to itself, cinch down a ziptie for each end. Not too tight because you'll need to adjust the slack on the cable.

2) wrap the cable around your waist with the ring facing forward. Tighten the slack on both ends of the cable around your waist. Feel free to put your balls and penis through the ring, however, it's not 100% necessary. You want it tight enough so that you can slip it off easily like underwear. Make it too tight or too loose? That's why you have an extra 5ft to do it again.

3) take it off by sliding it down like underwear (or panties). Use a marker to mark both cables on either end. Not remove the zip ties and use your washers to crimp the cable together. Don't forget to match up your marker marks. Where the crimp is doesn't matter. Cut off excessive cable and done!
Good news, you can now use any cage you'd like.
Photos to follow.

 

Tools

 

Process

 

Before and after.

 

Yeah I wasn't keen on the idea of the crotch strap. Something getting up in my business end doesn't sit will with me at work. It's plastic coated yes. Im likely going to plastidip the ends so they don't rust.

 

Find me one for $4 lol

 

You can wear literally any device you want with this belt, that's the best thing about it. It holds up a heavy metal cage and keeps it from sagging. It pulls just enough inward pressure to eliminate turtling.

 

I was thinking it would chafe or become uncomfortable but I'm almost 24 hours straight in it so far. As long as it's not too tight, everything is all good.