Stretching PA

I never went to a piercer. I started at 12 gauge and am not at 0.

From 6 to 0 happened in last 2 years. Lots of lube to move up. Some discomfort for a day.

I'm not sure about you. Mine was well healed while yours is very new.

 

You don't worry about this for at least another month or 6 weeks.

For my first stretch I went to the piercer. Subsequent ones I did myself. If you do it yourself there is no pressure to complete the stretch in an appointment; if its not ready you can bale out and try later or another day.

I spread the stretching over a few days by adding PTFE tape to the jewellery, but it is useful to have a taper as well.

 

Ive slowly gone up a size in jewelry every few months, seems to get easier as u go bigger. Dont rush it. Im now at 00ga. The jewelry starts getting heavy and I have just ordered some light weight titanium pieces ( not that easy to find at 00ga) When allowed its very well received, my KH loves it finds it very sexy

 

Let it heal well first. Get where it is supposed to be established so when you finally go to stretching that the hole stays where its supposed to be. It WILL migrate if stretched too soon or heavy wgts are used trying to stretch!! Your piercing will tell you when its time to go to the next size. When your piss is coming out of both holes n no you dont have to go back to the piercer. Use oil to insert n realize this stretching to 00g will take a year or longer. Thats how long the tip of your dick will remain sore.
00G jewelry is some MONSTER size jewelry to hang off the end of your penis. Hats off! Im perfectly happy at 2G.

 

Mine was done at 2.4mm and after some months I found that it was loose enough that a 3.2mm went in with no stretching. By maybe a year it took 4mm again with no particular stretching although some lube and gentle persistence was needed, 5mm within the next year was much the same, I had a taper and maybe used some PTFE tape but in the end it took a few tries over a week, stopping when it felt like it might tear. The final step to 6mm took many sessions of stretching, the most effective being to hold the taper in place under a little tension for an hour or so at a time. That step took some work and has never really loosened although it rotates freely so I've left it at that for the best part of twenty years now as it's a very useful size for retaining chastity devices anyway.

 

PTFE tape is used by plumber to seal treaded pipe connections. (Polytetrafluoroethylene teflon based) You will find it in any hardware/DIY store. Amazon will also supply if you are still in lockdown

 

My piercing progress from 18g to 0g - 6 months. Of these, it took about two months to heal the initial puncture.

I made all the stretches by myself. The only and most important advice is not to rush. Let the stretch fully recover.

 

Pierced and stretched to 8g same day.
A few months later I noticed the piercing was loose so I just inserted a 6g with no problem.
Few months after that, same thing. Went to a 4g with no stretching involved.
Guess I'm lucky. Jewelry and sex have done the stretching for me.

Also, keep an eye on your healing. If you feel that your piercing has been sore too long, you might have a metal allergy, even a slight one can be an issue. My piercing was never really comfortable until I switched to titanium.

 

The less the difference between your current size and your future size, the easier it is. I 3d printed in 0.2mm increments and each stretch was painless and I just felt like my piercing was "full", which resolved in a day. If you can produce minimal changes with each stretch it is so much easier.

 

you can dedicate this job for your keyholder... 1 gauge up= 1 full orgasm