Hi, so I am now locked, but my problem is that when I get hard, my cock pushes everything down. Almost all the shaft became big before the cage starts, and then basically only the tip of me is inside (filling the cage). The ring is also pushed down, because the cock become much longer when hard. Does it means that I need a longer cage? I don't understand, to me seems like an impossible problem to resolve. When it gets hard it will always push things down.
I wouldn't go for more length. Instead i'd start looking into getting a narrower ring and tube. The Problem is, that the penis is able to fill up with blood completely and get hard. A narrower tube doesn't allow you to get to full hardness and so it won't push as much. And a narrower ring will help to minimize slipping, so it doesn't get as far down, but some slipping always occurs. My rule of thumb is, the cage part should match the flacid penis in length and diameter at max. If possible go a bit narrower and a bit shorter. But that's just my opinion.
Thank you. The point is: it's already almost too narrow! It's tricky for me to put it on. Impossible to use a narrower one (I tried). My penis cannot become bigger inside of the tube, it does it outside, and so starts to push down. Idk, the length may be the issue, like maybe I should have inside the tube all of the penis up to its base, when instead I do have like one-two fingers free, and those start to swollen and start problems. I also thought of a smaller ring, but it's so difficult to put on even the one I have now. Mmmm thank you tho.