Hello! I'm Josielynn - long time CD and lover of everything femme and silky and lacy and sexy! The most important people in my life know this and love this, even if it has taken a backseat since children came along. Chastity was one thing I had never had the opportunity to try. I never wanted to waste my money guessing whether something would fit, and too frugal to pony up for the custom items. I wandered in here yesterday for the first time while on a google search for 3D printing a chastity cage - I have to say I've enjoyed reading about the adventures and passion y'all have shared. I had my first experience this evening when my printer finshed printing off the last cage piece (which I knew would be too short, but had to try it anyway) of a the "No Fun Chastity cage" on Thingiverse. I had to make the ring where it ended just above the pins so I could cup it around my testicles and pull it up as opposed to feeding everything through. I had no luck, getting everything fed through even after a hot shower with everything nice and loose. This worked as it clamped onto the front ring which provided the upper support. Picture nervously fumbling getting things in place in my panties and as I get one side pinned in place, I feel something I was not expecting. Before I could even get the second clip in place, I was cumming into my cage and panties! It was a complete surprise and made quite the mess, but I eventually got the second pin in place and cleaned up a bit. As expected, the cage was way too short, but now that I know this feeling, I'll be cumming back for it again for sure. Hugs, Josielynn
Hi Josielynn and welcome to the Mansion. There are plenty of friendly, helpful people on this site, and plenty of useful information. Have a look around and ask questions. A 3D printed chastity cage - who would have thought? Not me! There is info on cage sizing in the forums, so might be helpful to have a look at that. I hope you find what you are looking for here.
I've learned that a cage that's a little short is a good thing as it controls those nasty erections long before they get started. BTW, I also have a 3d printed KTB device that, although painful, works very, very well. I must wear that on certain occasions, such as going through airports.
I tried harder again this afternoon, and was able to get everything in place using the full ring. It took a lot of handling and fidgeting and wound up cumming again before getting everything pinned in place. Surely, I'm not the only one who's had this experience? I was able to wear the cage comfortably for about four hours or so this afternoon. I read through many of the posts in the crossdressing forum (my first and favorite kink) to see how well the cage would contain me, and wow did I really feel its presence when I got to an especially hot post. It did do it's job and didn't pull up too painfully, and the cage was even slightly roomy when I wasn't busy getting aroused. More experimentation to come - maybe I'll design my own, or try one of the other printable versions - I can see some shortcomings with this one, and I'd really like a cage was an attachment for a strap-on (vac-u-loc likely) now that I know it can be secured. Has anyone come up with any kinky ideas for attachments that might fuel the imagination?
This new idea of 3-D printing sounds like something I need to investigate. Custom Fit at Home. Interesting.
It's been wonderful. I found a few pre-designed, and the first one I printed has been effective and luckily the ring and small cage seem to be just the right size. I'm going on 15 hours wearing it today after 13 yesterday. I slept in it for half the night, putting it on when I woke up to pee at 3 AM. I'm going to try leaving it on through the whole night tonight. I am looking forward to trying a Holy Trainer v2 3D print tomorrow providing the print doesn't fail tonight.