Hi, I'm hoping to get some thoughts on what seems like a problem to me when it comes to sizing and what to do about it. More often than not, I've read that it's best to measure the ring size after a warm shower or bath so that there's some blood flow, the issue though, is that my balls alternative between hanging really low and being really loose, and tightening up along with the ball sack much closer to the body. This would mean that technically, if I had measured for a ring where my balls might be significantly lower and away from my body that I'd need a ring that's quite a lot tighter, not to mention the fact the weight of a metal ring would cause it to slip down, but, if I do this then when my balls would want to tighten up again I could then be at risk of it being too tight. If I reverse the process and try and measure when they're close to the body and tight then when they loosen up a lot they'd simply fall out of the ring. I'm not sure what to do here, I don't have a particularly large ballsack, and I'm not all that large in the other region when flaccid. I'd say if I were to measure with a tape measure and pushing the tape measure back a bit on the skin to the tip, I'd estimate a flaccid length of around 3-4 inches, rising to around 5-6 when hard. I have experimented with cages before, I've found the metal ones being quite heavy, and when hard it moves the ring forwards effectively causing some discomfort on the balls. Looking for thoughts, recommendations and advice! Will also open a little poll to get a generalised survey of answers.