How inescapable is your cage?

Well if you check the picture of the tetherspout system on their website it shows in one of the pictures a titanium round thick locking mechanism that slides over the end of the tetherspout and locks in with a very special screw

 

Mine's secure enough to keep me in there when I really don't want to be but a hack-saw could make medium-quick work of the plastic. I want a steel version of the same that would be much much more difficult (and expensive) to hack off (if at all). "Mental" restraints do nothing for me.

 

I've worn one of those and it's simple to escape from. When I'm cold not so easy but when I'm warm my ballsack is loose and allows the device to slip 3-4 inches down and then I can easily pull out of the back. And I was on the smallest ring. To be honest when I've seen pictures of guys wearing various cages they all have a lot more body fat than me in that area to bunch in front of the ring and stop it slipping.

 

i think my wud be a bit easy cos it a plate that push everthing inside me but i wud not try cos Mistress wud know what i have done.

 

I guess that's true. Are you skilled enough to use a hacksaw around your bits? I'm not.

 

I guess I'm thankful to be fat... For once! Lol!

 

My circumstances are similar with a Vice Mini. It would be too painful and bloody to try to get out and I'd never get back in without the key.

 

Can you explain what a retainer ring is and how it works?

 

Does the Vice anti pull out work that well? I thought since it’s just plastic narrowing device you could gently and slowly pull out of it. It also seems that even if if can’t prevent pull out it WOULD kinda hurt when you get aroused since it’s squeezing pretty tight across the width of the shaft.

 

Mine is fully lined with spikes that hold me on place, I could try and pull out but I’d be left looking like Freddy Kruger gave me a hand job. And as mentioned by elfman a hack saw would make easy work of the device. But it’s not worth betraying my Madams trust.

 

It's worked for me. I tried pulling out when I first got it after wearing it for a few days. I stopped when it got really painful and ended up bleeding. They claim that after a couple of days, the penis conforms to the anti pullout making it difficult to get out of. That seemed to be the case for me.

It can start to hurt when you get aroused. I've had that experience occasionally, usually when my KH gets me very worked up which happens now a lot. Because of my cage size, I don't have much room to grow but more than I would wish. I've got it adjusted to the smallest sizing options. It doesn't usually get painful like that until I've been wearing it for a long period - more than 10 days. Removing it, cleaning, lubing a little and putting it right back on seems to reset things. I've been using it exclusively for 15 months wearing it 24x7 and haven't needed a break other than for cleaning & a shave.

 

Similar experience here. I am in the HT V5 Nub. I have been through several CB models and even had "pull out prevention" added. Nothing has been as tight and secure as the HT Nub. I tried the small but still had some room to grow.

Once I went to the nub with smaller ring, and as long as I get the testies all the way through before locking on, it goes no where till Mistress/Wife decides to bless me with the key....and that is a very rare thing!

 

which cage?

 

Pain from erections is the ONLY reliable way for me to not cum. It seems I can get aroused enough in nearly any non painful cage to have an orgasm. The erection just grows inward toward the pelvis. But spikes or pain actually works to stop an orgasm.

 

I wear the kink3d too. Recently downsized from the S to the N+ narrow. I agree with your description of comfort, but I could slip out of the back easily. Thats when we the wife made the appointment for the piercing. Can I get out of the cage now? Yes, but not without destroying the cage or causing serious injuries. The piercing has made the whole experience very real.

 

I need and so does wife that I cannot slip out
But no piercing
Constructed a flat plate that hides lock and rests on top of cage
Added a chain
2 padlocks
Cost 10 bucks
And has not been removed for a year now

And no pull-out
It's made my chastity real
And she knows it

 

What is it about the HT Nub that prevents you from being able to pull your penis out while keeping your balls still secure?

Does anyone else have this same experience?

 

So you basically turned your cage into a full belt by adding the chain to go around your waist? I tried that a few years back and it does work but you can always cut the locks off and pull out if you want. We abandoned that idea because I could cut the locks if I wanted too. After awhile it also got uncomfortable to wear.
I think the Tetherspouts are the best because they act like a PA without the piercing. With the security screw locked in the end of the hub it's impossible to access without the specified key and it's recessed so you can't mess with it. It also works with any kind of ball trap device. Just my opinion.

 

I'm not sure it's the only reason, but there is a little lip at the top-back of the tube that extends slightly into my body. When I try to touch the spot where I thought I'd be able to pull out, I can only touch that piece. Additionally, and I don't know how dissimilar other devices are, but the way the ball trap is shaped, it pulls my sack skin over the top of the tube. It's sized and shaped perfectly to keep me from pulling that skin away (with no pinching or pain... Unless I try to move it. I've learned to not try). If I try to slip the cage down, it only moves a fraction of an inch and it is painful.

 

It’s a custom 3D printed device, fellow member castmenow did the original design it’s called the iron maiden, and he kindly modified these to the dimensions I needed. I then had it printed by sculpeo.
You can find the designs in the 3D print thread in the devices section of the mansion, and I have pics in my album.

 

I tried small HT5 , but I had one uncomfortable "almost" pull out in first 2 weeks. I went to the NUB with smaller 45cm ring.

For me at least it's all about how I put it on and lock. I pull foreskin thru and then make sure to work both testicles into sack outside the ring. Then slip the penis under and thru. When I fit/slide the nub carefully in place penis is compressed hard back into sack and the testicles outside the ring in combination prevent and pullout, ring sliding or testicles movement trying to go back inside.

Its pretty tight but surprisingly not uncomfortable for me. With exception of hygiene time once in a great while I wear (required) for long extended periods of weeks and months without a break period

I never had same experience with cb or even ht nano .

As they say your mileage may vary and it's truly about the fit and feel for the individual

Good luck and hope this helps

 

I am on honor system because found that I could escape all the cages, and the security is my mind and our relationship. Haven't masturbated without permission for two years.

 

I purchased this little device from Ali Express. It works with my resin and steel HTv3 devices very well, Once it is on pulling out is very hard if not impossible.
I am circumcised. The three soft little sticks touches the top of my penis. Once you try to pull the member out you feel their presence.
It really hurts. Otherwise it is very comfortable.
I don’t think that it is possible to remove it without unlocking it. Even somehow if I manage to remove it without breaking, it would be impossible to put it back without unlocking the device.

 

This is how it looks when its on.

 

Do you have a link to that?