Hello all, We are having problems with pulling out. This isn't intentional but keeps happening when he sits down or bends down. Is there a way to prevent this? Any help or advice on this would be greatly appreciated as it is driving us to distraction.
What kind of device? Is it too big/long, etc.? Is he overweight (it matters)? A standard ball trap device is easy to pull out of, but he shouldn't be 'falling out' when sitting or bending over.
I fit this situation as well. Please define it a little more. It the tio retracting from the end of the tube? Are the balls pulling through? Is it sliding all the way out the back. If I get a little more info and it is similar to my own situation, I may have suggestion. Please, do NOT send a pic in a PM.
i have found there are 3 things that effect easy pullout' first is super growers are also super shrinkers. my puck can sit at his desk without a cage on, shrink and retract so nothing is outside his groin but his balls. 2nd is the circumfrence or the package which will determine the size of the base ring, testicle can shrink in size for many reasons but the scrotum will not shrink near as fast or at all. using hormones i was able to shrink my pucks balls from a combine 123 ml to 33 ml but the base ring area still measures 12.5 inches. that leaves me the choice of purple balls or easy out. 3rd are the size of the thigh. when i started locking him up he had 32 inch thighs with no fat. hormones have them down to 28.5 each. this still leaves no room between the legs at all. the whole package has to sit on the thighs with outward pressure. i have literally watched him walk across the room and the cage just falls off to the floor. so i pierced a pa on him and it has yet, on its own , to come off again. i have also used urethra cages that work well too but cleaning the tube is very important. extra time has to be allotted for him to clean it right. after a few uti's he has paid close attention to it's cleaning.
The ring size above was key for me. Using the anatomic shaped rings 1.75"/45mm is too tight, and the 2.0"/50mm I would pull through. It was all about the gap from the bottom of the tube to the ring below. I went to a 2.0"/50mm true round ring and got a desirable narrow gap and looser fit. Also, the shorter the tube the better to combat turtling.
I just got a Lori 2A with a retaining ring. A properly sized retaining ring will prevent pull out quite well. I am pleased that I can not pull out of the 2A device. The essential point is that you need to get the smallest diameter retaining ring possible that is consistent with long-term wear.
Weight loss might help, but ir will not prevent turtling and therefore pull put for sure. If the problem is not the balls squeezing through the a-gap, but the penis only the best way to prevent unintended pullout would be a PA or a tetherspout.
I think that if you are very very little and even in a little cage your willy goes inside you then it not really pulling out and when it comes out of you again it will go back in the cage again so it dont matter dose it.
I have never been able to pull out of the stainless steel Nub that is equipped with a steel waist belt.