Picked up an ender v3 se. Getting used to cura program. I've found a few chastity cages online but what is the easiest way to edit like the base...
I second this. I haven't found one but I believe it's only a matter of time. Some people are resting at 1" long and are still pierced.
Thanks for the info. I am very intrigued. Where did you get the pa pin?
You didn't by chance print that evotion in your profile did you? Been interested in those but not the $500 price tag.
New to 3d printing. Is there any filament type that works better than others for printing a cage?
https://www.dailycardinal.com/article/2022/03/students-asked-to-wear-chastity-belts-following-return-from-spring-break?ct=content_open&cv=cbox_latest
Thanks for sharing. That looks promising. My only issue would be the bars. My erections are strong and I could see discomfort happening.
The setup was very secure. I had no access to remove the PA wand unless the "cage" was unlocked. Unfortunately there was still too much pressure...
Thus an "internal semi erection". It still happens by trying to fill your body cavity but that cavity is only so big. No device can completely...
Just ordered these. Going to drill the cage hole just big enough to slide the 10mm wand through. Comment if you want to see if it works....
Messaged Youming a week ago on Etsy and their website and no response. Do you think they're on hiatus for COVID again?