SOLD, Thank you.
I cannot, sorry.
I could fit better, compare it to the Cobra models. I purchased a clear plastic knock off and I did not fit at all. To each their own.
[ATTACH] [ATTACH] A representation only, note the profile “bump” on the top of the penis and the corresponding location on the cage.
The definition is the same it has always been, I just don’t get it so much anymore.
I have looked at the Bon4, I cannot see any similarities with the Bon4 cross section snd that of my penis. It looks like the 4 is “backwards”...
“tomorrow”
Flat front, actually pushes the whole pini into the abdomen
20 days in, no rubbing the tip, no urine issues.
Metal, negative capture with tether spout.
The space between a plastic ring and cage can be enlarged with a dremel with sanding drum. Some material can be removed without compromising the...
off……heal……get a cage so small it will not allow a hard on to even get started.(if there is one)
tether spout
not sure of the answer but I believe the 1 knuckle rule is for novices, just a starting place.
I have given thought to using a ss cath long enough to reach well beyond the first couple inches. Attach a 2 piece, 5/8” garden variety hose...
IMHO, if you can get an erection that big you need to drop a couple cages sizes.
Reduced to $69.00
They are not too bad if you fill both sides of the ring with a quality urethane caulk. Silicone sucks in this application.
Sent another message.