Hello everyone. I formerly owned a Jailbird with a cage diameter of 1 ¼ inches - which I sold to fund my next metal device. I'm favouring a Watchful Mistress next so thinking about sizes. I recall from wearing the JB that there was some space in the tube when flaccid (looks quite noticeable on my profile pic), so I am wondering if I should spec the tube on the WM a size smaller or keep it the same? Any advice would be most welcome. Thanks in advance.
The closer you get to filling the space when you are flaccid will help keep you that way when caged. Remember that as you begin to get an erection, your penis should be expanding in the cage and at the same time pulling on your balls which should help take away the hard on. It is the basic design for a chastity device. Pulling the balls away from your body should help you to lose your erection. The perfect fit should take up every bit of slack in the cage when you are flaccid without causing you to be bulging out of the cage constantly or hurting.
Smaller cage has few benefits 1. It is less noticeable under trousers 2. If it prevents even partial erection, then it is more comfortable for 24/7 wear With smaller cage you may suffer discomfort in the initial few weeks; but later it will be most comfortable All this is applicable provided you do not wish to have erecctions
its a teeny one that's got a tube and when it come it was 3,3cm but Mistress make it shorter and now its bout 2 point something cm. She bashed it with a hammer.
I found with mine that it's far more comfortable when it's a close fit, length and diameter, when my tiny dick tries to get erect. I still think I can go smaller in diameter, and on my next one I will make it 7/8" or 3/4" instead of 1". With a little lube, I easily slide right into 1", so I know it needs to be smaller for me. I'll have to get some rings and see what I fit through, and I'll go from there. You should go off what your old one was and adjust the new one according to how much less or more room you would prefer. You can purchase sizing rings from some manufacturers, and the rings will tell you exactly what you need for diameter, unless you're smaller than the smallest ring like I am
I believe that the shortest length that holds your normally flaccid penis is best. My JB is 1-1/2” in long and usually fills the space. But my penis can be swished a little more and I’m sure the ¼” smaller cage length (smallest MM makes) would still be fine. The whole point it to eliminate possibility of an erection, once that starts to happen the whole area expands and the base ring really gets tight (at least for me). It’s easy to show by getting an erection with the base ring around the penis and balls but without the cage. Everything tightens up fast!