hello- i have 45 mm and 40 mm ring sizes for cheap chinese devices- both are suitable even though being cheap the only down side is that my dick can now flop out of the 45 mm after wearing for years and the 40 mm ring is slightly too small to sleep in . any tips?
Go with the smaller one. Use Vaseline under the ring. It will fit if you keep it on for a few weeks. Be brave.
I'm in the same situation. Most chinese cages are sold with 40/45/50 mm rings, whereas my ideal would be 42mm. 40 is bit too small. To see the differences try to calculate circle area in any of cases mentioned - they're quite significant. It's not a matter of being brave but a matter to be safe, so any hints are appeciated.
I don’t think there is any good solution. I have been trying chastity on and off for years because I struggle to find a suitable ring (I have tight ballsacks). I am currently on the authentic K3D which already has much larger selections of rings compared to the knockoffs, but it’s still an issue that I’m yet to find a good solution to. Cold weather is an absolute nightmare. If I use a bigger sized ring, I would never know when a ball would pop out in the middle of the road. If I use a smaller one, balls get squeezed so hard to the base ring and cause redness and skins started peeling off after a few days. Vaseline/lubes are the easy option for a tighter fit, but they don’t truly work in long term - at least not for me at the moment. I hope it will get better with the smaller ring but I don’t know how long it’s going to take.
PA piercing may not be for everyone unfortunately. My missus doesn’t really enjoy all the BDSM side of things and a PA piercing (or indeed any kind of piercing turns her off completely). I’m not particularly interested in that either.
I had the same issue. I finally went with a resin design, Cherry Keeper, that offered ring sizes intermediate between the standard 5 mm ranges. So i now have 42 mm rings that fit perfectly, allowing for long term wear without slippage. Look at their website and see if it might work for you. Good luck and enjoy.
My only suggestion is order a ring sizing kit from mature metal find your actual size and consider a custom cage. I wish I would have done this but already ordered a custom cage with a base ring that might be slightly too big I'm between a 45mm and a 50mm
This also doesn't work great for growers (I can say from experience) I now have a Bad Ass WorkRoom BA-20P that I LOVE... it's perfect
Grind the 40mm ring larger, a mm at a time. A knockoff dremel will do the job fairly easily. Alternatively, build up the 45mm ring with teflon thread tape until it stops sliding off. You can then remove the tape, and build it up to the same diameter with epoxy putty. If motivated, you could use the escact measurements of your now ideal ring to order a custom or semi-custom.
Safety first! Watch put for any strange of painfull stuff. Hope you find something that works for you!
42mm? I have the same problem. I can barely get into a 45mm, but under certain conditions a 50mm can slip off. I've stopped using the 50mm, and just put up with the 45mm, but you don't want "too tight", because that can be bad for you physically.
if it's too tight, the skin there will darken and become cooler than the skin around it. If that's not happening you know you are fine.
My sack is darker at times other times its normal. When I first start a session the tight ring is always the biggest challenge, with ball burn. It takes some weeks before it goes away, and even then sometimes it tightens up for no apparent reason. I use baby rash cream as a ball lubricant, and that helps a LOT, and it stays there for at least half the day, if i am on my feet a lot during the day sometimes I might have to reapply but once it beds in its not necessary.