Steelworxx & Urethral Insert -- "Blow-By"

Hello All,

Recently acquired a Steelworxx Looker02 with the urethral insert.

I have been wearing a MM Jailbird for several years now and, thanks to the exact proper fit, can adequately "line everything up" and urinate, through the bars, while standing, which comes in handy during a night out on the town. My only dissatisfaction with the JB is the security screw; while its the "low profile" nature is excellent, it is a real pain in the neck to secure and remove, and so I wanted something of high-quality with the cylinder lock (or whatever it might be called).

So the Looker02 fits great all-around. Even the standard insert (6mm with 8mm ball? I'm guessing; I haven't actually measured it) goes in and stays in with no discomfort. The problem: the dreaded "blow-by" when urinating.

Now I don't mean that just "a little" gets out from around the tube, I mean that it is pouring out, both from the small holes at the end of the cap, and even from around the top of the cap (where it joins with the bars). As such, it will be *barely* hygienic enough with even *daily* removal for cleaning and maintenance, to say nothing of the customary (and much-preferrred) *weekly* program. (Not to mention that I would ALWAYS have to find a way to sit.)

Have any of you Steelworxx wearers, upon first experience with the standard insert, found the similar problem? What did you do? Did you order a larger insert? With a bigger thru-hole? Did it work?

I'm definitely bummed about the idea of having to send the cage back to Germany (if in fact that becomes necessary, for proper fitting?), but without getting a larger tube to prevent blow-by, the item will not be usable for its sole intended purpose.

All comments welcome!

 

Excellent responses, each of you, so I thank you.

Servus, I hadn't thought of trying the "pressing" technique, but I will the next time...

 

Oh yes, I otherwise do; I only mention that being able to stand (with the Jailbird) is exceptionally helpful at times.

But even sitting, with the Looker, makes a mess, and will not be acceptable (in its current state of affairs) throughout the work day. Fatter tube with bigger bore may be the only possible solution; will report back if I try it, and it works.

 

Servus,

It is the removable type, so the tip has the threads on it that go through the hole in the cage, and is secured by the little nut.

Now, regarding the pressing technique, I have NOT tried it yet, but that's because the JailBird has gone back on (and so far stayed on). It did occur to me that the Looker02 cage is rather short, so the, er, "equipment" is already much compressed inside of it, and so the tip of the penis (in fact, the whole head) is already pressing against the cap. As such, if I had to guess, I would imagine that the technique might not make any difference, but I do promise to report back when I get around to trying it, and see the results.

 

Kiesela,

Good point. IIRC I had fewer such issues when I was test-driving a knockoff, the tube for which was 1" longer tube, *and* was equal diameter throughout its length. (Not to mention, slightly larger than even the bulb of the Steelworxx tube.)

Perhaps, if I invest the $ and turnaround time, a longer and wider tube with a greater I.D. could make the item as close as possible to ideal.