I noticed same pinching with 60mm ring if ring was exactly same level with outer cage side bars. I have also 55mm ring which I have bent toward my...
I used dremel and cut off the attachment point of rod from my bare cage because I had same issue. I also reshaped cage little bit so it fits...
Well I made measurement mistake first time and ordered too large waistband. Luckily BB offered possibility to change to smaller waistband sides...
For me CS belts works best when belt is not too tight so tube is aligned to sit low enough. First I had it too tight and it caused problems...
https://behindbarz.co.uk/product/apollo-tube-cage-combo/ - says that tube has 36mm opening diameter but...
I just noticed there is picture about new cage and enclosed tube design in BehindBarz X/Twitter account. Looks interesting. I wonder how expensive...
Maybe their products are little bit expensive but in return you get good customer service. Something what is not always obvious. Thanks for sharing.
I have belt with bare cage and I have found out that with 4" tube it is little bit too small for me. With 3" tube it is okay but 3" tube is not...
I have found best fit by bending front part of the belt itself so front part or belt sits in nice angle against my lower abdomen. This also brings...
I agree. I have been reading lot of communication issues with some other manufacturers and I have been also very pleased to find out that Behind...
I did read this same hint from some other thread and this was exactly what I needed to get perfect fit. It just had to read all old messages from...
My only experience from balltrap devices is CB3000/CB6000S, which I really could not use more than couple hours at time. I recently finally bought...
I can push my thumb between belt and skin in left or right side at time and barely palm in front or back. Fit is snug but not extra tight. I did...
Thanks. Good pictures. This helped a lot. Foreskin is not issue for me either. In fact I think this design probably prevents pinching which I...
I wonder how big distance there is left between bottom of tube and bottom of bare cage when 4" tube is used. At the moment I don't have outer cage...
At least my order has been in "Processing" state since I place order two months ago.