Mansion folks please help... Need advice on adjustments to Jailbird.

Discussion in 'Mature Metal' started by wannabe slave d, Jun 14, 2016.

Top Posters
  1. wannabe slave d
    Online

    wannabe slave d Junior Member

    Joined:
    Jun 10, 2008
    Messages:
    115
    Likes Received:
    93
    Trophy Points:
    28
    Local Time:
    10:51 AM
    #1 wannabe slave d, Jun 14, 2016
    Hi,
    I hope some of you out there can offer a bit of advice...

    My Jailbird finally arrived yesterday and I'm very pleased with it.

    However, I don't know I managed it but I appear to have got a couple of measurements slightly out.
    The base ring seems a little on the large side and also, I think the gap might be a little too wide. I'm wanting to push the cage further down on the mounting post of the ring, but of course it needs to line up with the hole...

    Thankfully the cage itself fits perfectly, but when any sort of arousal occurs, I find that there's about an inch or so of my shaft that becomes hard behind the base ring and pushes everything forward.

    I hope some of are able to understand where I've gone wrong and suggest the suitable adjustments.

    Thanks in advance.
     
  2. Billus
    Offline

    Billus Laconic.

    Joined:
    Jul 31, 2010
    Messages:
    974
    Likes Received:
    986
    Trophy Points:
    103
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    10:51 AM
    #2 Billus, Jun 14, 2016
    Contact MM and explain the situation to them. It's not uncommon to get a few measurements out of whack the first time. You'll have to send it back to them anyway, so it's best to let them guide you in what to tweak.
     
  3. wannabe slave d
    Online

    wannabe slave d Junior Member

    Joined:
    Jun 10, 2008
    Messages:
    115
    Likes Received:
    93
    Trophy Points:
    28
    Local Time:
    10:51 AM
    #3 wannabe slave d, Jun 14, 2016
    Thanks, yeah I've already done that, but was curious as to whether others had experienced similar issues,

    Not sure whether I should order a smaller base ring or just have the gap narrowed.
     
  4. Billus
    Offline

    Billus Laconic.

    Joined:
    Jul 31, 2010
    Messages:
    974
    Likes Received:
    986
    Trophy Points:
    103
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    10:51 AM
    #4 Billus, Jun 14, 2016
    I would suggest you try to determine if the problem is whether the gap is too big or the cage is too long. If your gap is too wide, your balls will try to slide out. Too small, and it will restrict blood and normal movement of the balls. A small gap just gives you constant pain, like you've been kicked in the nuts repeatedly.

    As for the base ring, it's possible it's too wide. Any little adjustment in some of these areas can make a big difference. You might try purchasing a slightly smaller ring. Keep the one you have, so you'll have options if necessary.
     
    1984marriedcouple and wannabe slave d like this.
  5. MillionDollarMeaning
    Offline

    MillionDollarMeaning Member

    Joined:
    Feb 25, 2016
    Messages:
    20
    Likes Received:
    10
    Trophy Points:
    3
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    USA
    Local Time:
    5:51 AM
    #5 MillionDollarMeaning, Jul 13, 2016
    I had to send mine back and forth to MM several times before I got a good fit. And even now, I'm suspecting the cage portion could be smaller. Since they can't resize the diameter, my plan is to wait until I get used to wearing this one for a while, then getting a smaller diameter.
     
    wannabe slave d likes this.
  6. wannabe slave d
    Online

    wannabe slave d Junior Member

    Joined:
    Jun 10, 2008
    Messages:
    115
    Likes Received:
    93
    Trophy Points:
    28
    Local Time:
    10:51 AM
    #6 wannabe slave d, Jul 13, 2016
    Thanks for that. Luckily the cage is a perfect fit and the gap is fine..I'm sending it back in a week or so, when I',ve been paid and going for a smaller double base ring..Fingers crossed, that'll do it.
     
  7. Thatgirl
    Offline

    Thatgirl Owner and Wife of Thatguyontheinternet.
    Verified Female

    Joined:
    Feb 1, 2016
    Messages:
    847
    Likes Received:
    3,045
    Trophy Points:
    123
    Gender:
    Female
    Local Time:
    5:51 AM
    #7 Thatgirl, Jul 13, 2016
    My locked boy, @Thatguyontheinternet used Plastidip to both make his base ring smaller, and to prevent sliding of the cage. Couple that with a little plastidip on the tip of the punishment pin, and you got a cage that barely moves.
     
    1984marriedcouple, ChasteHubby2015 and wannabe slave d like this.
  8. Deleted member 43235
    Online

    Deleted member 43235 Guest

    #8 Deleted member 43235, Jul 13, 2016
    I think you want a tighter ring. Holds it better and prevents a gap. Noticed this with my CB
     
  9. cold97
    Offline

    cold97 New member

    Joined:
    May 3, 2016
    Messages:
    9
    Likes Received:
    4
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    2:51 AM
    #9 cold97, Jul 23, 2016
    Damn, I just got mine and experiencing the exact same issue. When I put mine on, the base ring seems way too loose for some reason or is it the gap? If I stand up and hop up and down a couple of times, I can slide out of the cage. When I get erect, it just pushes everything forward and get a couple of inches of shaft. I used the sizing rings too, the cage seems spot on though.
     
  10. wannabe slave d
    Online

    wannabe slave d Junior Member

    Joined:
    Jun 10, 2008
    Messages:
    115
    Likes Received:
    93
    Trophy Points:
    28
    Local Time:
    10:51 AM
    #10 wannabe slave d, Aug 27, 2016
    Ok, so I got my Jailbird back the other day and it still isn't right.
    I've emailed MM and while I know that their customer service is second to none and I'm sure they'll offer practical advice, I though I'd ask the folks on here if they have any insights, just to broaden my knowledge and possibly offer alternative angles.
    I'll just paste in the email that I send MM-

    Hi,
    well I had some time yesterday to try the Jailbird again and I'm sorry to say that it still doesn't seem right.
    I'm not at all suggesting that you're at fault, but I'm not really sure what steps to take next.
    Although the base ring is significantly smaller, once locked the device still slips down. Some of this is down to the weight of it, then as soon as any sort of swelling occurs in the base of my shaft, that pushes the cage further down. I was hoping that it would sit firmly at the base, preventing any kind of erection.

    I'm wondering if I needed the gap altering after all, I don't know if an even smaller ring would be possible as with this one, I struggled a little to push everything through, would the next size down allow for that?
    I tried it on again this morning without doing what I did yesterday (watching porn etc) to see how I would cope with just wearing it throughout a regular day and and discovered that without too much effort, my penis could 'back out' of the cage while still locked.

    I'd appreciate any suggestions you have about where to go next. Although it's disheartening to think that I may have to send it back to you again, in the long run, it's more important for me to have a secure device before I go any further on this journey, so if it means saving up a while and waiting longer for a device that is inescapable, then so be it.

    One other thing, while wearing it for a few hours yesterday, made more secure with a length of nylon under the base ring and tied round my waist, I got myself pretty worked up, smoking a joint and watching porn and was disappointed to find that with a little pulling and rubbing I actually reached orgasm while caged. I realise that, from accounts on the Chastity Mansion site and other sources, that a locked orgasm is a possibility with enough determination, I just didn't expect it to occur quite so easily, or I wouldn't have manipulated myself quite so vigorously.

    I really hope you can help, any advice you have would be gratefully received.
     
  11. Thatguyontheinternet
    Offline

    Thatguyontheinternet Owned by Thatgirl

    Joined:
    Jan 21, 2016
    Messages:
    651
    Likes Received:
    1,115
    Trophy Points:
    123
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    Florida
    Local Time:
    5:51 AM
    #11 Thatguyontheinternet, Aug 27, 2016
    If your balls hang low / loose it's nearly impossible without modification to get a ball trap cage to "sit firmly at the base". Smaller base ring and smaller gap will help. But eredtions will push the cage off your body no matter what, since you have essentially loose skin for a few inches until the cage hits the balls, which is what secures it in the first place.

    If it doesn't bother you (it bothered me) to have the gap be VERY small, then that's one of the biggest factors. And along with a snug ring will make it as good as it can be.

    You can test this all without sending it back. As my far better half mentioned, we used plasti-dip to effectively reduce the ring diameter and add some friction. But you can just wrap some tape around the bottom of the ring for the same effect. If you find it works, then work on longer lasting solutions (I didn't care to send mine back).

    For the gap, just roll some cotton balls into joint shaped tubes and tape tightly around the back of the A ring. This will effectively reduce the gap. None of this will hold up to any wear, but it will help you identify ways to make the cage fit better.
     
    jim48, wannabe slave d and Jamie's-Locked like this.
(You must log in or sign up to post here.)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice