Electric Dog Collar

Discussion in 'Chastity device discussions and reviews' started by Dumb1, Dec 7, 2009.

  1. madamsboy
    Offline

    madamsboy Looking for a special female

    Joined:
    Jun 12, 2008
    Messages:
    722
    Likes Received:
    15
    Trophy Points:
    18
    Gender:
    Male
    Local Time:
    3:37 PM
    undo the tips from the receiver unit and wrap each one with a piece of bare wire. then run the other end of the wire to wherever you want to juice applied.
    I used speaker wire since it is already 2 wires that run parallel to each other.
    Pics upon request
     
  2. slavehubby
    Offline

    slavehubby Senior Member

    Joined:
    Nov 10, 2008
    Messages:
    113
    Likes Received:
    1
    Trophy Points:
    16
    Local Time:
    8:37 PM
    Dont know a whole lot about electricity play. Very curious. What happens when the caps are left on the electrodes?
     
  3. madamsboy
    Offline

    madamsboy Looking for a special female

    Joined:
    Jun 12, 2008
    Messages:
    722
    Likes Received:
    15
    Trophy Points:
    18
    Gender:
    Male
    Local Time:
    3:37 PM
    little to nothing. they act as insulators keeping the electricity from reaching its target
     
  4. Dumb1
    Offline

    Dumb1 senior member

    Joined:
    Oct 10, 2009
    Messages:
    1,775
    Likes Received:
    1,308
    Trophy Points:
    133
    Gender:
    Male
    Occupation:
    trade
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    8:37 PM
    madamsboy you say undo the contacts and attatch a wire would that be possible then to attatch that to the steel tollyboy belt perhaps? and if i did wouldn,t that make a circuit and b"llock things up:spider:
     
  5. slavehubby
    Offline

    slavehubby Senior Member

    Joined:
    Nov 10, 2008
    Messages:
    113
    Likes Received:
    1
    Trophy Points:
    16
    Local Time:
    8:37 PM
    I wondered what would happen if you used an electric device with the Lori#2 steel device. Would the whole steel device deliver electricity to you so that it is more than one would want? Light one up like a Christmas Tree.:CMrocks:
     
  6. madamsboy
    Offline

    madamsboy Looking for a special female

    Joined:
    Jun 12, 2008
    Messages:
    722
    Likes Received:
    15
    Trophy Points:
    18
    Gender:
    Male
    Local Time:
    3:37 PM
    the reason for 2 contacts is so that your body is the connection between the 2 for the electricity to flow through.
    I do not believe you would feel much of anything using a metal device in the middle.
     
  7. Dumb1
    Offline

    Dumb1 senior member

    Joined:
    Oct 10, 2009
    Messages:
    1,775
    Likes Received:
    1,308
    Trophy Points:
    133
    Gender:
    Male
    Occupation:
    trade
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    8:37 PM
    ok so if i used just the one terminal connector to the belt and the other to the body would that work?:anim_12:
     
  8. Dumb1
    Offline

    Dumb1 senior member

    Joined:
    Oct 10, 2009
    Messages:
    1,775
    Likes Received:
    1,308
    Trophy Points:
    133
    Gender:
    Male
    Occupation:
    trade
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    8:37 PM
    i dont know why i just asked you that madamsboy it was easier to just test the theory out and .....yes it does work and it also makes the terminal that is touching the skin jolt more than if it is just on the skin alone...there thats my scientific experiment done for the day all in the cause of submissiveness:scared0016:
     
  9. madamsboy
    Offline

    madamsboy Looking for a special female

    Joined:
    Jun 12, 2008
    Messages:
    722
    Likes Received:
    15
    Trophy Points:
    18
    Gender:
    Male
    Local Time:
    3:37 PM
    I think part of it has to do with surface area of the contact. I haven't played with that theory yet though.
     
  10. Dumb1
    Offline

    Dumb1 senior member

    Joined:
    Oct 10, 2009
    Messages:
    1,775
    Likes Received:
    1,308
    Trophy Points:
    133
    Gender:
    Male
    Occupation:
    trade
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    8:37 PM
    have been tinkering with the unit and with the terminals removed i think that it could easily be attached to the belt or any other device used . have tried it with it just resting under the front shield with no prongs fitted at all and it still gives one hell of a jolt when set above 5 or 6. have posted some photos i hope they come out ok and show how compact the unit is.
     

    Attached Files:

  11. Dumb1
    Offline

    Dumb1 senior member

    Joined:
    Oct 10, 2009
    Messages:
    1,775
    Likes Received:
    1,308
    Trophy Points:
    133
    Gender:
    Male
    Occupation:
    trade
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    8:37 PM
    just to clarify the picture a little the wire you see is the antenna and is what picks up the radio signal from the remote control. Anyway i was told to show my wife what it was i bought last night and i think after getting a little bored(typical)with my explanations of what everything did and how it might work in practice she just said "put it on then" and go upstairs...i tried to say yes but you have to......just get up the stairs! i tucked the reciever into the front shield as in photo and dashed up stairs only to hear a faint beep and then have a jolt before i got past the top step. Is it working she shouted up at me? it certainly was and by the feel of it she was holding the button down causing it to continue shocking for 8 seconds and then it stopped. phew that was surely higher than the number 5 i had set it to . It then went again beep and then my groinstung like mad as the reciever had slipped down the shield a little and the terminals or at least one of them was pressing against my right b"llock.........i shant say what i shouted out to my wife but she wasn,t impressed with me. After i came back downstairs she told me she liked the device and wanted me to get it sorted into something she could make me wear discreetly by the weekend........oh and that little tantrum you just had means you have added another week of lockup in the tollyboy belt.:anim_37:
     
  12. Greatcornbow
    Offline

    Greatcornbow Member

    Joined:
    Apr 17, 2009
    Messages:
    98
    Likes Received:
    9
    Trophy Points:
    8
    Local Time:
    8:37 PM
    I think there might be a few of these as Christmas presents....
     
    Joroincharge likes this.
  13. slavehubby
    Offline

    slavehubby Senior Member

    Joined:
    Nov 10, 2008
    Messages:
    113
    Likes Received:
    1
    Trophy Points:
    16
    Local Time:
    8:37 PM
    I'd get one for my wife as a Christmas present! I think she would like it very much!
     
  14. Joroincharge
    Offline

    Joroincharge Lock em up - 24/7/365!!

    Joined:
    Mar 10, 2009
    Messages:
    4,143
    Likes Received:
    2,427
    Trophy Points:
    143
    Gender:
    Female
    Location: (Country, Region - and perhaps even City?):
    England
    Local Time:
    8:37 PM
    I certainly hope so....

    <weg>

    :evilgrin0036:
    :gen085:
     
  15. Dumb1
    Offline

    Dumb1 senior member

    Joined:
    Oct 10, 2009
    Messages:
    1,775
    Likes Received:
    1,308
    Trophy Points:
    133
    Gender:
    Male
    Occupation:
    trade
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    8:37 PM
    well at least mt wife has removed the tollyboy belt this evening and i am a free man for a few days hopefully. That will give me a little time to try out a few ideas i have with regard the collar attachment and the fitting of it to a couple of other items eg cb6000, will report anything that seems a goer and if anyone has any thoughts or ideas please post them here.:anim_12:
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice