Drilling a hole in my cb

Discussion in 'Chastity device discussions and reviews' started by propertyofMistressLauren, Aug 21, 2010.

  1. propertyofMistressLauren
    Offline

    Joined:
    Jul 27, 2010
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    1
    Local Time:
    10:23 PM
    I now have a PA piercing which has rendered my cb6k unwearable as it is now. Since money is always a concern when dealing with chastity devices I thought I may try to remodely my CB.

    The issue is that I am too large to have the ring on the inside of the tube and I want to enjoy both the piercing and chastity. My thought was to reinforce he seam with super glue and put a hole where the peorcing lines up, but my question was "has anyone tried this or does anyone have a better idea until I can save the pennies to het a device that accomodates a PA piercing".
     
  2. maid_carrie
    Offline

    Staff Member Moderator

    Joined:
    Nov 23, 2008
    Messages:
    1,594
    Likes Received:
    1,343
    Trophy Points:
    153
    Gender:
    Male
    Local Time:
    4:23 AM
    It seems that heat is the best way to get a neat hole in a CB6K

    This video may assist in the required technique

    http://www.youtube.com/watch?v=zUF90iypYxY
     
  3. gyrator53
    Offline

    gyrator53 Member

    Joined:
    Nov 16, 2008
    Messages:
    250
    Likes Received:
    133
    Trophy Points:
    43
    Gender:
    Male
    Occupation:
    retired academic/consultant
    Location: (Country, Region - and perhaps even City?):
    UK
    Local Time:
    3:23 AM
    My only reservation about using heat to make the hole is if the plastic is acrylic or similar. Acrylic can be neatly shaped and worked using heat however it does set up stresses in the material that can cause stress cracking especially if the stressed area is subject to any solvents. Strangely this happens even when the solvent isn't one that dissolves acrylic (e.g. isopropyl alcohol).
     
  4. alphonsus
    Offline

    alphonsus Junior Member

    Joined:
    Dec 2, 2009
    Messages:
    12
    Likes Received:
    3
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    3:23 AM
    They're made from polycarbonate, if I remember correctly.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice