Just finished my latest cage upgrade but as my wife has told me she’s not interested, I’m sadly not telling her. I’ve increased the angle so it points almost straight down so making it more discreet. Also more generously rounded the ‘short side radius’ and added extra bars at the top for strength and security
Thanks! It’s taken many modifications and trials to get here I really want to try and see if I can ‘pull-out’ but I’m too scared too It would be amazing if I genuinely can’t but sole destroying if I can
A very nice looking cage! You are very talented! If you don’t want to pull out, add a few blunt spikes or points to that top bar, it would make it impossible without shredding your penis,
Thanks for all the likes! It’s 129g and here are some more photos in natural light... It started off as a Chinese one that I purchased of this group. The cage was just a series of rings - way too long and big. The only original bits now are the back ring and the attachment point for the cage! Even that has changed to reduce the ring gap. It’s also has flats on ether side so it can’t rotate.
Very creative. Hope it provides you with the control you desire. Too bad your wife isn't interested, but you can always hope she'll see the light.
Had an hour to my self this afternoon so modified the locking method. I’ve always wanted an internal lock as the rattle padlock always looks so vulnerable. Well, that was too hard to do so I’ve made a new Abus fit in a different way. It’s less exposed but the padlock lock its self does hold the cage on. I don’t think it will be problem as it’s impossible to pull it hard and the padlock seems very well made. My wife has gone out for the evening but I asked her to take the key. She replied that she didn’t think we where doing ‘this’ anymore so I said that it was just for this evening. She accepted I so now have it on
Looking great! I love the innovative attitude. You must work in the shop alone? I've tried a low temp brazing rod for stainless steel with my mini map torch to no avail. Any suggestions?
Yes, if the children aren’t hassling me, I’m on my own! Sorry no experience with that type of brazing but if it’s anything like brazing with brass or hard solder - get everything really clean, use the right flux and make sure it’s hot enough. I had some hard solder I just couldn’t melt with straight propane. I now have a bottle of oxygen for cutting and getting things just that bit hotter