i was wondering if anybody else had this happen. the cuff ring broke where the base alignment post goes through. it was to small of a piece to glue. only had it on three weeks. had the number 2 ring on and the smallest locking pin. i do alot of bending over and physical work and was wondering if there is to much pressure. any help would be appreciated.
The 2" A-ring broke back in March, so i had to go down a size in the ring. Then one of the post came off, i took the other post out and crazy glued them both. It's been holding... ALE customer service is great for working with you. AMiller143@aol.com later my CB6000s split the bottom seam, sent it in for warranty got it back and just like the ring i sent then back in and the manufacturer replacemed the parts. No issues so far with the new parts.
I have had 2 A rings break on me they were the solid rings from the CB2K. I was using them with the CB3K the #1 ring broke after 3 weeks straight of use so I went down the the size # 2 ring that one lasted a while but it finally broke after extended use. I got 2 replacements from the Millers.