Hello, I ‘m wearing a ball trap cage since around 6 month. All fine. Now we like to ad more security against pull out. There are a lot of pa-devices out there but nearly none for a apadravya which I think is practical or suitable for me. My piercing (5 years old) is now 3mm and I plan to go up to 6mm but canging the pin is always not easy and the piercing will close in hours then reinserting can be very painful. I‘m looking for a device which locks the barbell in place like one design from evotionwearables but in stainless steel not plasic and an integated lock, not a strap. Or a way to lock the piercing in a standard cage like the pa-locks available. The piercing is 20mm long straight so the standard locks are not working. I can think of a 5-6mm flesh tunnel with an easy to change lock but can’t find one. Do anybody uses his apadravvia? Any experience to share? Thank you for your help.
I have an MM jailbird and use a ring through my apadravya to lock down. Interestingly I did reach out to evotionwearables, and they were willing to design a custom device to fit the piercing.
Thank you for your fast response. What kind of ring are you using? A ball enclosure ring can be easily opened without a trace. Welding a ring in place sound sexy but scary too My wife enjoys sex an demands a easy and fast solution for unlocking. I contacted evotionwearables too but they do not have a 3D metall printing process like DLS working - perhaps in the future.
Check my pics. They were from when I had my 00GA PA; I needed pliers to open the ring. I just sized up my apadravya to 7/16" and am using a tribal ring with a locking screw similar to the one for the MM cages; Mistress holds the key. I am in a bit of a different situation than you, there is no PIV, therefore, no need to unlock. I agree the metal pin is a must for long-term use in a piercing; I was not aware evotionwearables could not do metal pins. Thanks.
They do metall pins but we prefere a 100% metall cage - as closed as possible (no stimulation without her). And a cockring device to add a pain faktor for the pleasure of her sadistic and my masochistic side. This could be a problem when having a fixed pin inserted. I belive there can be a lot of stress to the piercing in both directions where the diretion of a PA seams to be in the right „vektor“ and throughout a more flexible part. I was thinking to devide the piercing in two piece, the upper part ending in the utera with a small ball or plate and the lower as a PA. But the distance of the lower hole to the tip is quite short and I‘m afraid to split it.
The lower PA part is much more fragile. The top has a lot of mass and is more flexible. Sizing up and healing takes some time, but well worth it.