That looks a bit like a copy of the jura cocoon belt (which I have). I haven't tried this copy though. from experience with other ebay offers...
It isn't terribly hard- using the US post office international package service is reasonably priced. there is some additional paperwork for a...
I suspect Behind Barz could accommodate you, however, I would recommend new waistband sides. Reason is the back plate is thick, straight and rigid...
For #5 - you can use dental irrigators- inexpensive plastic (curved) syringes to irrigate the tube.
You can ask them to add an irrigation hole for cleaning (they accommodated this on my order), can inject water/soap inside to extend the wear time
91 cm, appreciate the consideration
The belt can sit right under a larger belly (like mine) without issue, just need to measure it at that point and work with the practice belt to...
Thanks for the suggestion, will give that a try!
Thanks for getting back to me- I have the belt on the bed, just trying to align the waistband connector into the front module and get the round...
Hello, I've received my Carrara 2.0 belt a week ago and have been struggling to get it to close/lock properly. I understand the waistband is...
That looks like the Yooka belt which was more in the $400 range when working with him over Twitter DM
That is the measuring instructions I recall, he really needs the measurements and then a front body shot and side to rationalize the measurements...
You might try this one:...
If the debugging model is like Yooka's or Jura's it is about sending in measurements to the creator, a resin/plastic (low cost) model is produced...
You can reach him over Twitter DM, that's how I got my belt made/shipped to the US
Update - the gents at BBRZ are sending a replacement to me gratis (shipping charge only), very nice of them.
Thank you Timberwoof - I did contact them but so far no response, still hoping someone on the forum has had the same problem before and received...
Hello -has anyone been able to source a replacement center nut; preferably for a BBRZ 3point belt? Somehow I misplaced mine. Thanks!
Thanks for that update- I had contacted him in 2022 and put down a deposit for a March 2023 production slot -but if he's still working on last...
It would be something custom (they've done custom work in the past). I had a front cage similar to that bought from someone on CM.