Able to slip partly out of CB6000s, any suggestions on different chastity to buy?

get a real chastity belt ,most devices are just toys ! reg. GWENY

 

Gweny is right save up and get a proper belt

 

As a less expensive route into full belts take a look at the Lovejail from Fetish Felix - a full belt only its made from polycarbonate. All the security of a full belt without the big cost.

As an alternative - try using a length of chain or other material to secure your CB6000s against your body - you can attach the links into the pins in the place of a spacer, this should keep the device against your body to prevent pull/slip out. The flat style chain as used for some dog leads would be more comfortable and if it works you could sort some sort of cover for it to make it more comfortable still - I roll the waistband of my underwear back down inside the belt of my lovejail to relieve the stickyness against the skin and provide a small measure of cushion.

 

they might be only toys but Mistress likes to see mine and if i ever tries to take it off i wud get paddled that hard that i wudnt be able to sit down for weeks.

 

Use a smaller ring and spacer.

 

do you need a new pin for that?

i was thinking of trying it....but then i realised as the smallest pin was meant to work with a little spacer, it could slide back and forth once the lock was on. i worried that might be.....pinchy!

 

Simple solution get a PA and secure the Pa ring through the hood slot. Ive seen cables lock lock back onto the A ring after going through the Pa ring as additional security, or just a small padlock through the PA ring. There are also lockable PA rings.

 

I guess fine KTB like one from malechastitynow.com may be a good solution. No testie ring, no tube, no piercing, cock is mostly open for any hygienic purpose but you cannot pullout, get hard or come. If you are grower (it seems so from your story), use intense or severe version with less inner diameter of spikes.

 

The simple solution for that is to put the spacer on the end of the pin, next to the padlock instead. It takes all the slack out of the system. When using a "the curve" I added a small white rubber washer, this took every last little bit of movement out as it had to be compressed slightly to get the padlock in. This did make locking up slightly more of a task but it was worth it to remove the pinching problem completely.

 

of course! how silly of me :3

thank you ever so much

 

There is also the KSD-G3 anti-pullout devices from keptforher.com. They caused an abrasion for me after awhile and now I have the new points of Intrigue for the CB6000s which I find are much better. I don't turtle any more (or grow).

 

hey were can i get a real belt from? Im in australia and realy wish to buy a real chastity belt. ..not a deiice ..like u said they are toys

 

yes they are toys,,i live in namibia /southern africa and i am very happy with my belts.i took all measurements by myself and it worked for me . neosteel is shipping world wide and there service is great !! check here >>>>>>>>>>>>>>
http://www.neosteel.de/Nsepmain.htm
for me they are one of the best beltmakers . since 8 years i deal with them and never had once a bad expirience. i live in africa you in down under ,the masterpiece system ,without any profiles or linings is the best solution for our climatical conditions ,trust me !
for more info , pics etc. feel free to contakt me ..
best regards ..GWENY

 

Ive only been in chastity 3 weeks and i love it, once i get the neosteel i will be much better secured and no way to slip out!

I want to live in chastity forever!

 

well that is reight,,you can not go wrong with neosteel ! greetings GWENY