It seems like sometimes i can fit into my 45mm ring for my A271 and other times, the boys won't go through and i need to switch up to my 50mm ring. Then, in a few days, i can go back down. Does this happen to anyone else? If so, any tips on how to deal with this or what causes it? asa
Maybe not that much, but yeah, sometimes my ring holds everything tight and under control Other times, my smaller ball slips out. Can't figure why one and not the other.
You need to lessen the ball gap - if your finger can fit then your ball will too - that help me when I was wearing a small metal cage Now I wear a cherrykeeper 3D printed cage and ring
I found this to be very true. My cage has always fit incredibly well until a cold dip in the ocean at the Jersey shore. Slipped right off me, but thankfully not out of my trunks lol
Thanks for your responses but i don't think i was clear. My issue is that sometimes, my ball won't fit through the 45mm ring, so i need to go up to my 50mm. Then, next time i'm out to clean, i can usually get back through the 45mm. So it's not an issue with them riding high or low (they do that too) and i can't go smaller still. Anyone use ice in this situation to shrink the testicles? That would only make the sac smaller, though, making it harder to get back in. I suppose the best option is to never take the base ring off, but I'm not quite there yet. asa
Try putting it on when having a warm shower, testicles will drop and become supple to pop through the ring. Leave the ring on as it is untill you finish showering and drying and getting dressed. The last item in the cage part. All this time allows for the testicle skin to settle and cool
Do you not experience any flex in the softer plastic of the Cherrykeeper that lets the ball gap open wider? Just curious as thats the problem I had with it (as well as it holding on to odor
How about leaving the base ring on? If the smaller ring works once it is on, leave it on. Shave around the ring.
No that’s why you get the connection part on the ring with small degree down so it will reduce the ball gap - once I add that change never had a ball slip - Odor - I shower daily so not too bad View attachment 30486
The attachment doesn't work and what connection part are you referring to?? LOL yes I shower daily too, it just seems to hold on to urine smell.
On the cherrykeeper your ring with part the receives the cage part and the lock goes through it - on the ring connection can get a downward degree like 1-5 percent with will push the cage to ring and reduce the ball gap -
i think it’s cause it is printed not moulded, the plastic is slightly porous so will trap microscopic drops of urine.
No matter how many degrees down I went, the cages soft plastic still flexes and had resulted in multiple ball escapes (very painful) if I could get my cherry keeper in harder plastic or (gasp) metal it would be a perfect device