I am very seriously considering a Neosteel. Not sure which type, but leaning to the Arch. Is there a way to secure a Prince Albert piercing? I see that MySteel has a little chain, but I don't see any similar options on the Neosteel site. We are starting to plan a trip. Sometime in May seems likely. Tripp
Asking Mr. Mende the same thing there is no need with the Arch for something that secures the Pa. It is tight right up close and there is no way for him to touch himself let alone pull his dicky out. On the other neosteel belt we had a special adataption made. There was a small bar at the bottom of the penis tube that allows the securing of the Pa ring. Once it was locked on there was no access to the Pa ring. Now he permanently wears a simple solid tube that is secured to his Pa.
well ,i have a P/A , my ringsice is a solid 10mm , i had to grind the ring slightly oval ,but it fits nice in the "arch" ,but it is not chained or used as a security , i am not abel to pull out of the "arch" anyway !! reg. GWENY
You could probably get it, but I doubt you'd need it. I have a PA fixing for my carrara but I basically never use it as its completely unnecessary as full belts tend to be secure enough as they are.
oh yes ,, i did the piercing myself , 1mm i stretched the hole to 12mm , and all those rings i used over the years fit in the "arch" . when did the first hole ,i was in the belt an hour later , no problem at all , just a little antiseptic cream and that`s it !! P/A and "arch" works very well together ,but not my T/V belt the pipe is at the T/V too short ! hope i answered your questions . best reg. GWENY
my message might be quite late, but i can report something to both topics - pa-piercing and masterpiece arch. normally it takes a few weeks until the pa-piercing is healed enough so you don't have to check it every now and then. it also depends on the size of ring you want to have. i started with 2.4mm and ended up with 10mm. it would be sad if you cant see the piercing when you get into the tube again, right? what i tried is getting a small padlock through the holes at the end of the tube and through the pa-piercing. but i never succeeded to close the padlock. you just can't close it if the bar is inside the tube. you can loop a string through the pa-piercing and get that through the little holes of the tube. that is the easiest way to fix the piercing inside the tube and if you are lucky you can replace the string then with something else. probably a padlock if you find one in the right size... greetings, smb
After I had recieved my Neosteel Sports belt and found I could pull out with some soap and water in the shower I contacted them and they did say that for the "special few" that could pull out they do make a PA pin that would hold a PA ring in place in the tube for no pullout. The only issue for me was having to send it back and start all over with the fitting and my wife wasn't so keen on the idea of the full belt. She took to the ball trap device much easier. So they can do it, more than anything the Arch was developed after I had my sports belt and holds a lot tighter than the standard belts.
Even though I don't need it I was intrigued by the idea. With a loop done with a small cable tie around the PA and a padlock you can achieve a PA fixing. If you cut the red loop she would know as you can not get the lock back in the same setting without the key.
I have developed the thought a bit further. This is probably the easiest way to go about it. When you get used to this set up it its very comfortable.
How on earth did you get the numbered plastic seal through your PA and back out the tiny hole? Does the seal rub on your legs?