Thanks for the information. I've done a bit of reshaping of the cage with a rubber mallet which has helped a lot but I'll think about the dremel...
I'm in a BehindBarz belt after trying a couple of the cheap(ish) ones from the far east. With those I found the rubber liner to be a nightmare: it...
I filled in the ring with hot glue gun to make it tolerable until I could source a genuine ring which is extremely comfortable despite the square...
I'm a similar shape to you (high'n'tight, rather small balls). I've tried many different cages with a variety of ring sizes, some with different...
Hi Folks, I've just acquired via a well-known auction website one of these awespme belts as it happened to be the right configuration for me based...
The cb-x website sells 2.25" and 2.5" rings as separate spares, should you still be in need.
I've found a sanitising hand gel can help immensely, especially if it's the sort that contains aloe vera, etc. Does lubricating, moisturising (the...
I go for either very loose or very tight (i.e. compression) underwear. I tried placing an appropriately sized deodorant can cap over the end -...
I put glue from a hot glue gun in mine - works a treat.
The locking posts are drillable if you take sufficient care. I took the longest one (no way I'll ever need that) and assembled everything without...
I've tried most of the CB-x devices and I find the 6000s the most comfortable of the lot. I've been wearing it almost constantly (note: not...
They're made from polycarbonate, if I remember correctly.
I use boxer briefs with both a CB3k and a mancave. The only difficulty is the tendandcy to head left and get stuck down the leg, which can put a...
I've had problems with a CB3000 under work clothes, though I don't think anyone really realised what was going on. Tight underwear does help (I...