China Ascetici series : EMCC Belt - Delux Version

Discussion in 'Chinese devices' started by Panda, Feb 6, 2017.

  1. Panda
    Offline

    Panda New member

    Joined:
    Nov 16, 2016
    Messages:
    9
    Likes Received:
    46
    Trophy Points:
    23
    Gender:
    Male
    Local Time:
    7:36 PM
    As last year end, I just wore the EMCC belt economic version and post some experiences in here.
    But finally, the economic version has on my BF body (he wore) and so I need to buy one new belt.

    So, I choice the EMCC delux version for my next belt.
    And the delux one is as the photo as this thread shown.
    (https://www.chastitymansion.com/for...ign-stainless-steel-male-chastity-belt.18575/)

    With all economic version advantage but also add some new of the delux one.
    1. Much more conformable than the economic one with the new sharp of the belt design.
    2. Much more belly conformable with the lock system due to not so raised as the economic has.

    For the belts on me until now is about 11days and without take off.

    Of course the cleaning is easy with the belt on due to it has the opening door under the tube.

    I like this belt so much.

    2017-01-28 07.22.25 (复制).jpg
     
    Desairs, LongTimeLurker and spaiii like this.
  2. spaiii
    Offline

    spaiii slave prince albert

    Joined:
    Dec 24, 2008
    Messages:
    48
    Likes Received:
    268
    Trophy Points:
    53
    Local Time:
    1:36 AM
    My new EMCC belt is in shipping, and the unit just before this one where the pelvic plate is a solid piece and thus the locks are exposed a bit taller than yours.

    As well the trap door is a different design retained by a security screw just below the tube curve apex rather than the lock at the bottom of the tube. I really wanted the newer deluxe version as yours but I got something very close in design for about a 1/3 of the deluxe models.

    Thanks for posting your photos and review. Always fun to see another male in a device that I'm wearing ... soon ;-)
     
  3. Corsetbob
    Offline

    Corsetbob Active member

    Joined:
    Dec 31, 2016
    Messages:
    77
    Likes Received:
    74
    Trophy Points:
    38
    Gender:
    Male
    Occupation:
    Electronic Engineer
    Location: (Country, Region - and perhaps even City?):
    UK Northants
    Local Time:
    11:36 AM
    I was very tempted to get this belt until I found a cage that is sufficient. Will still be very interested in your experience as I would love a full belt but neosteel and the like are just too expensive. I am also overweight 105kg with beer belly so not sure if full belt would be suitable.
     
  4. therush
    Offline

    therush New member

    Joined:
    Aug 25, 2010
    Messages:
    8
    Likes Received:
    2
    Trophy Points:
    1
    Gender:
    Male
    Occupation:
    House Husband
    Local Time:
    11:36 AM
    sent you a conversation, if you want to reply
     
  5. Stuckinsteel
    Offline

    Stuckinsteel Member

    Joined:
    Apr 1, 2017
    Messages:
    30
    Likes Received:
    82
    Trophy Points:
    18
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    North East IN
    Local Time:
    7:36 AM
    I also like this belt. I have a very slim waist, but it can adjust to fit me securely very easily It is a fine quality belt. My girlfriend and I really like the cylinder locks, they just look awsome.
     
  6. Dev810
    Offline

    Dev810 Active member

    Joined:
    Oct 28, 2013
    Messages:
    125
    Likes Received:
    44
    Trophy Points:
    38
    Gender:
    Male
    Occupation:
    Technology Engineer
    Location: (Country, Region - and perhaps even City?):
    Birmingham, Alabama
    Local Time:
    6:36 AM
    I am thinking about getting a similar version of this belt, how would you rate the pullout security of yours and does the tube get super gnarly that it would be difficulty to keep clean 24/7?
     
  7. Panda
    Offline

    Panda New member

    Joined:
    Nov 16, 2016
    Messages:
    9
    Likes Received:
    46
    Trophy Points:
    23
    Gender:
    Male
    Local Time:
    7:36 PM
    I think the security is pretty good if your waist length and the back wires length are all at the correct and suitable measurements.

    And the clean is very easily with the tube open, I think there is no difficulty to keep clean of 24/7.
     
  8. Freaky Rabbit
    Offline

    Freaky Rabbit Long term member

    Joined:
    Jun 29, 2018
    Messages:
    230
    Likes Received:
    221
    Trophy Points:
    53
    Gender:
    Male
    Occupation:
    my own business
    Location: (Country, Region - and perhaps even City?):
    Iowa, USA
    Local Time:
    6:36 AM
    Few questions. I got the same belt, but they sent me wrong size, so I am waiting for replacement. What is the longest you have been able to wear this belt? Do you have it so tight that you cannot escape? Does it sit on top of hip bone, or right below it? Thanks!
     
  9. Panda
    Offline

    Panda New member

    Joined:
    Nov 16, 2016
    Messages:
    9
    Likes Received:
    46
    Trophy Points:
    23
    Gender:
    Male
    Local Time:
    7:36 PM
    The longest I wear this belt without take off is 12 days....
    Also including cleaning without take off.
    I think I can keep more days because these is no uncomfortable
    But at that time, I need to take airplane at the next day, so I need to take it off.

    I can't escape when I wear this belt, the fit is well.

    The belt shoud be on top of the hip bone, it will be more comfortable and security.
     
    Spike6411 likes this.
  10. steph17
    Offline

    steph17 Junior Member

    Joined:
    Sep 26, 2009
    Messages:
    425
    Likes Received:
    316
    Trophy Points:
    63
    Gender:
    Male
    Local Time:
    11:36 AM
    I have just received the exact same belt, the emcc deluxe version, I have adjusted the belt to fit and will see how comfort is after a day or two and make more adjustments if needed, so far comfort is not bad but it takes a few days to get uses to wearing a full belt.
    The belt is secure I could not get my penis out of the tube and I have tried, the tube pushes the balls apart and it feels ok but mine sit high and tight so there is not a lot of room for them to spread but I think it should be ok.
    For the money you pay you get not a bad product, I had a cararra concept belt and the quality was great but the expense was painful and I really thought the belt was way to bulky.
    It is early days yet but the first impression is quite good, I will post more in a few days.
     
  11. steph17
    Offline

    steph17 Junior Member

    Joined:
    Sep 26, 2009
    Messages:
    425
    Likes Received:
    316
    Trophy Points:
    63
    Gender:
    Male
    Local Time:
    11:36 AM
    I have adjusted the belt again and went back to two rear cables so I can get the crotch (penis tube) piece to sit tight against the body, I have also added some padding at the front behind the locking plate and I have added a PA fastening so the belt is really secure and reasonably comfortable and I am sure it will be fine when my body gets fully adjusted to full time wear, you do not need to remove the belt to clean, just the plate at the under side of the penis tube.
     
    Desairs likes this.
  12. Sissy-Jessy
    Offline

    Sissy-Jessy Active member

    Joined:
    Dec 26, 2008
    Messages:
    80
    Likes Received:
    212
    Trophy Points:
    53
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    Quebec
    Local Time:
    11:36 AM
    Really nice belt.
    I have the cheap version, I really like the inescapable feeling but my skin become really irritated by the belt.
    I can see in your picture that you've put some plastic protection around the belt.
    You did you did this ?
     
    Spike6411 and sissy_connie like this.
  13. Deleted member 99096
    Offline

    Panda, can you please measure the gap inbetween the locks on both the basic and advanced belt?
     
  14. mdbcum
    Offline

    mdbcum Active member

    Joined:
    Jun 20, 2023
    Messages:
    51
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    USA
    Local Time:
    6:36 AM
    I got this Belt different cage. My problem with it is adjusting the belt, I wore for 24 hours and had to take it off it bruised my hips. A work in progress. I love the look and feel just got work out the belt to fit my hips!! And you can now order four different cages that fit the belt!!! IMG_20230916_211810_702~2.jpg
     
  15. mdbcum
    Offline

    mdbcum Active member

    Joined:
    Jun 20, 2023
    Messages:
    51
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    USA
    Local Time:
    6:36 AM
    Iv a lock on the locking plate that will not lock it came with a extra lock but I don't know how to replace it?
     
  16. mdbcum
    Offline

    mdbcum Active member

    Joined:
    Jun 20, 2023
    Messages:
    51
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    USA
    Local Time:
    6:36 AM
    Figured out the lock! Also found out that you can get 4 different interchangeable cages for $36.00 this is a new one and I will get the other two. One belt 4 cages not bad IMG_20231007_174620_637~2.jpg
     
    Desairs likes this.
  17. Mimoza
    Offline

    Mimoza C7/D6 on the TomAllen-rectrix scale

    Joined:
    Jun 19, 2020
    Messages:
    59
    Likes Received:
    57
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    İstanbul, Turkey
    Local Time:
    2:36 PM
    My lockes are rusted. I am trying to replace then with the spares. I unlocked the plate. But I could not figure out to get the lock out of its box. Help please
     

    Attached Files:

    Desairs likes this.
  18. JessMal
    Offline

    JessMal Active member

    Joined:
    Jul 24, 2022
    Messages:
    108
    Likes Received:
    49
    Trophy Points:
    38
    Gender:
    Male
    Local Time:
    7:36 AM
    Looks like there's a threaded nut inside the hole. I suspect you need to find something thin enough to get in there and loosen it. Thin walled sockets, needle nose pliers, etc.
     
    Desairs likes this.
  19. mdbcum
    Offline

    mdbcum Active member

    Joined:
    Jun 20, 2023
    Messages:
    51
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    USA
    Local Time:
    6:36 AM
    Needle nose pliers worked for me
     
  20. Mimoza
    Offline

    Mimoza C7/D6 on the TomAllen-rectrix scale

    Joined:
    Jun 19, 2020
    Messages:
    59
    Likes Received:
    57
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    İstanbul, Turkey
    Local Time:
    2:36 PM
    Needle nose pliers… Life saver. I am back in my belt. Thanks
     
  21. cyberpunk004
    Offline

    cyberpunk004 Member

    Joined:
    Jan 20, 2024
    Messages:
    37
    Likes Received:
    2
    Trophy Points:
    18
    Gender:
    Male
    Local Time:
    6:36 AM
    this design has at least five cages in aware of, fully open(wire ), a fully closed one, the most common one is the tubes shown above or . i also technically consider one at the bottom a "cage" for these as it uses all the same hardware as the this belt, but often has to be purchased as a whole belt to get it.Alao to be
    sure this cage i have was made by another company but fits them too, its a rather comfortable design. . 20240317_112604[1].jpg 20240317_112620[1].jpg
    this is not all the variations but if your looking for this design and don't like the stock cage, this design seems to
    have many many ways to achieve your goal. Also i haven't' seen it *yet* but..if people are interested i can do a more comprehensive post on this.
    upload_2024-3-17_11-31-12.png
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice