Chastity right fit?

Discussion in 'Chastity and orgasm denial' started by adoreyou, Jul 14, 2016.

Random Thread
  1. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    im using cb6000 with 5cm ring and smallest spacer, and its a good fit when flaccid. But when i get erect the device pulls outwards, and the ring is pressuring on my balls, witch makes a being kicked/burning "pain" on the back of my balls.

    just wondering if its normal that is pulls outwards when you get hard or should the device be on the same place at all time?
     
  2. xcitedsisssy
    Offline

    xcitedsisssy cd/sissy michelle

    Joined:
    Jun 18, 2008
    Messages:
    727
    Likes Received:
    818
    Trophy Points:
    123
    Gender:
    Male
    Occupation:
    Retired
    Location: (Country, Region - and perhaps even City?):
    Upper Midwest
    Local Time:
    6:55 AM
    Sounds like the ring, spacer or both are a little to tight. Also try a little lube so things will slide around a little bit. Keep adjusting your sizing and try not to erect because even with a good fit it will be a little uncomfortable.
     
  3. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    i already use biggest ring, i'm not that interested in buying a bigger ring from cb for 20$
     
  4. xcitedsisssy
    Offline

    xcitedsisssy cd/sissy michelle

    Joined:
    Jun 18, 2008
    Messages:
    727
    Likes Received:
    818
    Trophy Points:
    123
    Gender:
    Male
    Occupation:
    Retired
    Location: (Country, Region - and perhaps even City?):
    Upper Midwest
    Local Time:
    6:55 AM
    oh sorry. my mistake. and I don't blame you for not wanting to purchase a bigger ring, I would just try a bigger spacer then. Other than that I don't have any more suggestions. Sorry
     
  5. jemima
    Offline

    jemima maid for my Mistress

    Joined:
    Dec 19, 2011
    Messages:
    12,158
    Likes Received:
    12,999
    Trophy Points:
    153
    Occupation:
    Maid
    Location: (Country, Region - and perhaps even City?):
    Birmingham
    Local Time:
    10:55 AM
    hello @adoreyou praps its cos your cage is a bit big and that you can get a bit hard in it and then it does that. If your cage wont let you get hard at all it ight not had it.
     
  6. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    looks something like this when erect
     

    Attached Files:

    • 222.JPG
      222.JPG
      File size:
      62.6 KB
      Views:
      44
  7. Guest 2048
    Offline

    Guest 2048 Active member

    Joined:
    Jul 3, 2016
    Messages:
    87
    Likes Received:
    91
    Trophy Points:
    28
    Local Time:
    5:55 AM
    yes try one spacer up from what you have now.. that helped me
     
    adoreyou likes this.
  8. jemima
    Offline

    jemima maid for my Mistress

    Joined:
    Dec 19, 2011
    Messages:
    12,158
    Likes Received:
    12,999
    Trophy Points:
    153
    Occupation:
    Maid
    Location: (Country, Region - and perhaps even City?):
    Birmingham
    Local Time:
    10:55 AM
    well that don't look too bad anyways
     
  9. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    hm, i think i should try 6000s, now the cage is way to big. :(
    my dick is around 7cm / 2,7inch flaccid, so i guess 6000s is the best chose?
     

    Attached Files:

    • ss.JPG
      ss.JPG
      File size:
      67.7 KB
      Views:
      17
  10. chastitylockdown
    Offline

    chastitylockdown Junior Member

    Joined:
    Jun 6, 2009
    Messages:
    110
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Local Time:
    5:55 AM
    That tube is definitely too long. A CB6000s would be better for you. You want the tip of your flaccid penis to always be touching, or as close as possible to the end of the tube.
     
  11. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    is it "dangerous" to wear this cage until i get the smaller one? (about 1-2weeks)
     
  12. chastitylockdown
    Offline

    chastitylockdown Junior Member

    Joined:
    Jun 6, 2009
    Messages:
    110
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Local Time:
    5:55 AM
    A little tug on the balls while attempting to get an erection is normal, but from your pictures it appears that you have a Chinese knockoff. Does your device have rings with grooves in them? If so then it's a fake device Those grooves will dig into the skin behind your balls and cause irritation. The real CB6000 has solid rings and doesn't dig into the skin that way. Also be aware of the tube splitting in half which can pinch your penis. A couple years ago I bought the same Chinese device on Ebay and had problems with the ring digging into the back of my sack. I wrapped electrical tape around the ring and that helped with the irritation behind the balls, but after a couple weeks the tube split. I was lucky that it didn't cut my penis.
     
  13. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    did it shatter or just brake in two parts? yes its a knockoff just for that reason i can try how it feels and get right size when i buy the real one. i don't want to waste 100$
     
  14. chastitylockdown
    Offline

    chastitylockdown Junior Member

    Joined:
    Jun 6, 2009
    Messages:
    110
    Likes Received:
    88
    Trophy Points:
    28
    Gender:
    Male
    Local Time:
    5:55 AM
    It just broke into two pieces along the seam.
     
  15. jemima
    Offline

    jemima maid for my Mistress

    Joined:
    Dec 19, 2011
    Messages:
    12,158
    Likes Received:
    12,999
    Trophy Points:
    153
    Occupation:
    Maid
    Location: (Country, Region - and perhaps even City?):
    Birmingham
    Local Time:
    10:55 AM
    when i had one it done that as well and i glue it back but it went everwhere and Mistress says it look a right mess now. It still is use on me when i'm milked tho.
     
  16. adoreyou
    Offline

    Joined:
    Jul 13, 2016
    Messages:
    27
    Likes Received:
    5
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    11:55 AM
    btw, should the foreskin be inside the cage or at the base?
     
  17. Deleted member 43235
    Offline

    It will take time for you to find your fit.

    Personally took me weeks. I was falling out at night. Balls were going blue. I found my fit.

    I use the second ring, small spacer. When you put it on make sure you get hot penis right to the top of the cage. That way it will be secure. Also when I get hard I get a bit of a burning pain. Not too bad though. It's worse at night cause the ring is pushing close to my balls but that's a nighttime erection and because I am laying down. My ring can move back and forth a bit from being hard and soft. A bigger ring I fall out. Smaller ring balls go blue. Hope this helps.
     
  18. ddh067
    Offline

    ddh067 Junior Member

    Joined:
    Oct 20, 2008
    Messages:
    111
    Likes Received:
    44
    Trophy Points:
    28
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    Scandinavia
    Local Time:
    10:55 AM
    The first device I bought (many years ago) was a cb6000. Not a knock off. That one split in 2 as well, so the quality wasn't good at all .

    If you like the design, by a cb6000s knockoff if you find it in stainless steel. That will not breake and it will not be smelly like the plastic ones
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice